Mechanical Properties Of Laser Welded Joints Research Articles

Laser welding of TiNi shape memory alloy and stainless steel using Ni interlayer

Laser welding of TiNi shape memory alloy wire to stainless steel wire using Ni interlayer was investigated. The results indicated that the Ni interlayer thickness had great effects on the chemical composition, microstructure, gas-pore susceptibility and mechanical properties of laser-welded joints. With an increase of Ni interlayer thickness, the weld Ni content increased and the joint properties increased due to decreasing brittle intermetallic compounds (TiFe2 and TiCr2). The joint fracture occurred in the fusion zone with a brittle intermetallic compound layer. The tensile strength and elongation of the joints reached the maximum values (372MPa and 4.4%) when weld Ni content was 47.25wt.%. Further increasing weld Ni content resulted in decreasing the joint properties because of forming more TiNi3 phase, gas-pores and shrinkage cavities in the weld metals. It is necessary to select suitable Ni interlayer thickness (weld composition) for improving the mechanical properties of laser-welded joints.

Microstructure and mechanical properties of laser-welded joints of TWIP and TRIP steels

With the aim of investigating a laser-welded dissimilar joint of TWIP and TRIP steel sheets, the microstructure was characterized by means of OM, SEM, and EBSD to differentiate the fusion zone, heat-affected zone, and the base material. OIM was used to differentiate between ferritic, bainitic, and martensitic structures. Compositions were measured by means of optical emission spectrometry and EDX to evaluate the effect of manganese segregation. Microhardness measurements and tensile tests were performed to evaluate the mechanical properties of the joint. Residual stresses and XRD phase quantification were used to characterize the weld. Grain coarsening and martensitic areas were found in the fusion zone, and they had significant effects on the mechanical properties of the weld. The heat-affected zone of the TRIP steel and the corresponding base material showed considerable differences in the microstructure and properties.

Concurrent laser welding and annealing exploiting robotically manipulated optical fibers

Present investigation reports on the effects of incorporating pre- and post-heating on the mechanical properties of laser-welded joints, in normal air condition. Two common types of steels, i.e. mild steel, and stainless steel were welded with Lumonic's MS 830 Nd 3+:YAG laser machine, with an output capacity of 400 W. Due to the low integrated energy input required for laser welded joints, the welded region are often cooled too rapidly via conduction to the surrounding material and atmosphere, which leads to hardness discontinuities in the fusion and heat affected zone. The effects of in-process laser annealing on the mechanical properties and microstructure of laser-welded joints are important in any manufacturing operation. To improve the poor weld characteristics, this work investigates the use of automated dual-beam delivery system to implement a pre- or post-heating technique, simultaneously with the welding process. The results show that proper selection of the control parameters for the pre- or post-heating can reduce the hardness of the weld significantly and improve the welded joints mechanical properties, such as higher tensile strength and better durability.