Mechanical Characteristics Of Samples Research Articles

Viscoelasticity and texture of spreadable cheeses with different fat contents at refrigeration and room temperatures

The effect of the 2 common consumption temperatures, refrigeration temperature (10°C) and room temperature (22°C), on the viscoelasticity, mechanical properties, and perceived texture of commercial cream cheeses was studied. Two samples with different fat contents, regular and low fat, from each of 4 selected commercial brands were analyzed. The selection criteria were based on identification of brands with different percentages of fat content reduction between the regular- and low-fat samples (35, 50, 84, and 98.5%). The fat content of regular-fat samples ranged from 19.8 to 26.0% (wt/wt), and that of low-fat samples ranged from 0.3 to 13.0% (wt/wt). Viscoelasticity was measured in a controlled-stress rheometer using parallel-plate geometry, and the mechanical characteristics of samples were measured using the spreadability test. Differences in the intensity of thickness, creaminess, and roughness between the regular- and low-fat samples of each commercial brand were evaluated at each of the selected temperatures by using the paired comparisons test. At 10°C, all samples showed higher viscoelastic modulus values, firmness, and stickiness, and lower spreadability than when they were measured at 22°C. Differences in viscoelasticity and mechanical properties between each pair of samples of the same brand were greater at 10°C than at 22°C because of the influence not only of fat content but also of fat state. Ingestion temperature did not modify the sensory differences detected between each pair of samples in terms of creaminess and roughness, but it did modify the differences detected in thickness. The joint consideration of sample composition, fat state, and product behavior during oral processing could explain the differences detected in thickness perceived because of measurement temperatures.

Sintering and Mechanical Properties of Alumina Ceramics Prepared by Nanosize Alumina

This work examined the mechanical properties of alumina that can directly be enhanced by ratio of nano sized alumina powders additives to micro size alumina powders (n/m ratio). These new materials have mechanical properties that are strongly grain size dependent and often significantly different from those of their coarser grained counter parts. The mechanical characteristics of samples were observed by using the indentation test system. This data shows that the relative density for the sample is increased with increasing Meyer hardness.