Diamond-like carbon (DLC) coatings show extremely good promise for a number of applications in automotive components as they exhibit excellent tribological properties such as low friction and good wear resistance. This can impact on improved fuel economy and durability of the engine components. Much work has been reported on the dry sliding of DLC coatings with less so in lubricated contacts and, as such, there is a need to further understand the tribochemistry of lubricated DLC contacts. Commercially-available oils are normally optimised to work on ferrous surfaces. Previous studies on DLC lubricated contacts have tended to use model oil systems rather than fully formulated lubricants and from this an interesting picture of lubrication mechanisms is emerging. Optimising compatibility between a surface and a set of lubricant additives may lead to excellent durability (wear) as well as increased fuel economy (low friction). In this work, the friction and wear properties of a DLC coating under boundary lubrication conditions have been investigated and the tribological performance compared with that of an uncoated steel system.A pin-on-plate tribotester was used to run the experiments using High speed steel (HSS) M2 grade plates coated with 15at.% hydrogenated DLC (a-C:15H) sliding against cast iron pins. A Group III mineral base oil, fully synthetic Group IV PAO and four different fully formulated oils were used in this study. Furthermore optical and scanning electron microscopes (SEM) were used to observe the wear scar and to assess the durability of the coatings. Energy-Dispersive X-ray analysis (EDX), X-ray Photoelectron Spectroscopy (XPS) and Raman spectroscopy analyses were performed on the tribofilms to understand the tribochemical interactions between oil additives and the a-C:15H coating.This study show that the durability of the a-C:15H coating strongly depends on the selected additive package in the oils. In addition the effect of detergent, dispersant and antioxidants on the performance of the molybdenum-based friction modifier (Mo-FM) and ZDDP anti-wear additive was investigated and results are reported in this paper.