Background and objective Low flexuralstrength (FS) and impact strength (IS) are major drawbacksin removable prostheses made from polymethyl methacrylate (PMMA). Attempts to enhance the strength and longevity of theseprostheses have been of keen interest among researchers. Nanofillers are new and advanced reinforcements that can chemically modify PMMA. Graphene and multi-walled carbon nanotubes (MWCNTs) were used in this study to evaluate FS and IS when added to polymer and monomer individually. Method Four groups were created based on the addition of nanofillers: no nanofillers - control; 0.5% by weight of graphene; 0.5% by weight of MWCNT; and 0.25% by weight of both. These groups were further subdivided into two according to the nanofiller being added to polymer and monomer each. The samples were then subjected to a 3-point bending test to assess FS, and an Izod impact tester was used to test IS. Results Decreased FS and FS were seen in all groups with the addition of nanofillers in the polymer (p<0.001). With the addition of nanofillers in monomer, increased FS and IS were seen in groups with MWCNTs whereas a decrease was seen with the addition of graphene (p<0.001). Conclusion Nanofillers should be added to the monomer of heat-cure PMMA instead of polymer; 0.5% by weight of MWCNT has shown the highest FS and IS when added to the monomer.