We have implemented the method proposed by Aldrich and Pass (Aldrich, J.E., Pass, B., 1988. Determining radiation exposure from nuclear accidents and atomic tests using dental enamel. Health Phys. 54, 469–471.) to measure both the interior and exterior portions of a tooth in order to determine the diagnostic X-ray component of the total dose in the teeth. This was done using a modified nondestructive approach of Haskell et al. ( Haskell, E.H., Hayes, R.B., Romanyukha, A.A., Kenner, G.H., 2000. Preliminary report on the development of a virtually non-destructive additive dose technique for EPR dosimetry Appl. Radiat Isot. 52, 1065–1070.) given in Hayes et al. ( Hayes, R.B., Haskell, E.H., Barrus, J.K., Kenner, G.H., Romanyukha, A.A., 2000. Accurate EPR radiosensitivity calibration using small sample masses. Nucl. Instr. Meth. A. 441, 535–550). Here only 5% of the total tooth enamel sample from an enamel crown was used for individual sample sensitivity calibration. A cavity response correction for the low mass samples was also used ( Hayes et al., 2000). The teeth were American wisdom teeth having unknown doses applied by the IAEA in the range of 0 to 1 Gy as part of the second international intercomparison ( Wieser, A., Mehta, K., Amira, S., Aragno, S., Bercea, S., Brik, A., Bugai, A., Callens, F., Chumak, V., Ciesielski, B., Debuyst, R., Dubovsky, S., Duliu, O., Fattibene, P., Haskell, E., Hayes, R., Ignatiev, E., Ivannikov, A., Kirillov, V., Kleschenko, E., Nakamura, N., Nathe, M., Nowak, J., Onori, S., Pass, B., Pivovarov, S., Romanyukha, A., Scherbina, O., Shames, A., Sholom, S., Skvortsov, V., Stepanenko, V., Tikounov, D., Toyoda, S., 2000. The 2nd international intercomparison on EPR tooth dosimetry. Radiat. Meas. in press). Final dose reconstruction estimates of the IAEA applied values showed a very high correlation ( R=0.996). The approximate excess dose measured on the outside of the teeth relative to the inside was 49±35 mGy which is attributed to the diagnostic X-ray exposure given to the America wisdom teeth prior to extraction. The method used showed only a small dependence on the accelerating voltage of the X-ray source.