Hydrodynamic measurements were made with a triaxial hot wire in the full-coverage region and the recovery region following an array of injection holes inclined downstream, at 30° to the surface. The data were taken under isothermal conditions at ambient temperature and pressure for two blowing ratios: M = 0·9 and M = 0·4. (The ratio M = ρjetUjet/ρ∞U∞, where U is the mean velocity and ρ is the density. Subscripts jet and ∞ stand for injectant and free stream, respectively.) Profiles of the three mean-velocity components and the six Reynolds stresses were obtained at several spanwise positions at each of five locations down the test plate.In the full-coverage region, high levels of turbulence kinetic energy (TKE) were found for low blowing and low TKE levels for high blowing. This observation is especially significant when coupled with the fact that the heat transfer coefficient is high for high blowing, and low for low blowing. This apparent paradox can be resolved by the hypothesis that entrainment of the mainstream fluid must be more important than turbulent mixing in determining the heat transfer behaviour at high blowing ratios (close to unity).In the recovery region, the flow can be described in terms of a two-layer model: an outer boundary layer and a two-dimensional inner boundary layer. The inner layer governs the heat transfer.