ABSTRACTThe Garhwal–Kumaun region of the Himalaya encompassing the state of Uttarakhand, India, has experienced several earthquakes in the past. Damage due to earthquakes is controlled by local site conditions, primarily resonance frequency and wave amplification from the ground. We present local site parameters with their site geology for 37 sites using ambient noise data. Horizontal to vertical spectral ratio technique is used to estimate the spectral ratio curves. Based on the type of curve, sites are classified into four classes, viz. clear peak, broad peak, double and multi‐peak, and flat H/V curve. Sites seen with clear or broad peaks are located on either soil or weathered rocks, thus indicating large impedance contrast and sharp discontinuity with large velocity contrast. Multiple peaks are observed in either soil or boulder bed and reveal large impedance contrast, probably representing shallow and thick strata. Sites with flat curves are found on weathered/phyllite/granite gneiss/granite schist rock types within highly dissected hilly areas. Fourteen sites have a peak frequency >6 Hz with a dominance of broad and clear peaks in the Lesser and Higher Himalayan regions. On the contrary, foothills and part of Siwalik sites exhibited a peak frequency between 1.14 and 4.94 Hz. The results demonstrate that sites with thick soil cover and boulder bed areas, that is, Doon valley and foothills, show low‐frequency peaks and hard rock or shallow bedrock sites, that is, Lesser and Higher Himalaya exhibit a higher frequency range. The estimated H/V amplitude and peak frequency values have shown a good correlation with site geology and geomorphology.