This paper describes the development of a unique rolling load simulator (ROLLS) for testing bridge superstructure with a footprint up to 4 m ×17 m, and its first application to test a full-scale 1220 mm ×900 mm ×16000 mm B900 prestressed concrete box girder. This facility at Queen’s University in Kingston, Ontario, is the first of its kind in Canada. ROLLS can apply cyclic loading in a controlled laboratory environment, under realistic highway scale ‘rolling wheel loads’, in lieu of the conventional ‘pulsating stationary loads’. It has two half-axles of a large tandem, each comprising a dual 1140 mm diameter air-inflated tires spaced at either 1.2 or 2.4 m. Each half-axle can apply up to 125 kN, representing the heaviest half-axle load of the CL-625 design truck of the Canadian Highway Bridge Design Code (CHBDC). The maximum travel range and speed are 14.9 m and 6 m/s, respectively. A case study involving analysis of a bridge with eight adjacent B900 box girders of 27.6 m span was carried out prior to experimentally testing one of the girders using ROLLS. Load distribution analyses were conducted using both (i) a finite element model of the full bridge under various CL-625 truck loading configurations and (ii) the CHBDC load distribution method, and both agreed well. Scaling analysis of the girder load share was then conducted to account for shortening it to 16 m to fit in the laboratory, resulting in two-115 kN ROLLS design loads, 1.2 m apart. Multiple passes were conducted at various loads of 40%–100% of the design load, at speeds of 1–5 m/s to examine the machine and girder behaviours. It was found that the applied load fluctuates by less than 10% of full capacity and a 0.13 s/cycle time lag occurs. The measured girder deflection and elastic strains were 11%–20% lower than predicted theoretically. With the two half-axles assembly spaced at 1.2 m, the apparatus has the ability to complete three million cycles in approximately 4.5 months if ran continuously at 5 m/s.