Layer-specific Measurements Research Articles

Single systemic right ventricle longitudinal strain: Intravendor reproducibility and intervendor agreement in children.

Strain derived from speckle-tracking echocardiography is emerging as a useful tool in the assessment of single ventricle function. The purpose of this study is to compare layer-specific longitudinal strain values in children with single, systemic right ventricles (sRV) using two commercially available software platforms (GE EchoPAC (EP) and TomTec (TT)). Two readers analyzed two-dimensional longitudinal strain on EP (v 202) and TT (v 2.21.25) in 40 pediatric sRV patients. Intravendor reproducibility and intervendor agreement between layer-specific measurements were assessed by intraclass correlation coefficient and Bland-Altman analysis. Absolute difference (AbΔ) and relative mean errors (RME) were calculated. Subgroup comparisons (stratified by age, heart rate (HR), and frames per second (FPS): HR ratio) were made. Median age was 4.4years. 32 (80%) patients had hypoplastic left heart syndrome; 19 (48%) were post-Fontan. Intravendor reproducibility was excellent with high ICC (0.86-0.97). AbΔ between readers was small (1.2%-1.5%) with interobserver RME slightly higher for TT (11%-12% vs 8%-9% for EP). Layer-specific intervendor agreement was poor (ICC 0.45-0.62). Default layer comparisons (EP mid vs TT endo) showed good agreement (ICC 0.72-0.77) and less variability (AbΔ 2%, RME 15%) than layer-to-layer. There were no differences in ICC for groups dichotomized by age, HR, or FPS:HR ratio. sRV strain values are more negative when using EP. Intravendor reproducibility for sRV peak longitudinal strain in children is excellent with acceptable variability between experienced users. Intervendor, layer-specific strain agreement is poor. Vendor default layer strain values show better agreement but are not interchangeable.

Engineering a 3D-Bioprinted Model of Human Heart Valve Disease Using Nanoindentation-Based Biomechanics.

In calcific aortic valve disease (CAVD), microcalcifications originating from nanoscale calcifying vesicles disrupt the aortic valve (AV) leaflets, which consist of three (biomechanically) distinct layers: the fibrosa, spongiosa, and ventricularis. CAVD has no pharmacotherapy and lacks in vitro models as a result of complex valvular biomechanical features surrounding resident mechanosensitive valvular interstitial cells (VICs). We measured layer-specific mechanical properties of the human AV and engineered a three-dimensional (3D)-bioprinted CAVD model that recapitulates leaflet layer biomechanics for the first time. Human AV leaflet layers were separated by microdissection, and nanoindentation determined layer-specific Young’s moduli. Methacrylated gelatin (GelMA)/methacrylated hyaluronic acid (HAMA) hydrogels were tuned to duplicate layer-specific mechanical characteristics, followed by 3D-printing with encapsulated human VICs. Hydrogels were exposed to osteogenic media (OM) to induce microcalcification, and VIC pathogenesis was assessed by near infrared or immunofluorescence microscopy. Median Young’s moduli of the AV layers were 37.1, 15.4, and 26.9 kPa (fibrosa/spongiosa/ventricularis, respectively). The fibrosa and spongiosa Young’s moduli matched the 3D 5% GelMa/1% HAMA UV-crosslinked hydrogels. OM stimulation of VIC-laden bioprinted hydrogels induced microcalcification without apoptosis. We report the first layer-specific measurements of human AV moduli and a novel 3D-bioprinted CAVD model that potentiates microcalcification by mimicking the native AV mechanical environment. This work sheds light on valvular mechanobiology and could facilitate high-throughput drug-screening in CAVD.

Engineering of a bio-functionalized hybrid off-the-shelf heart valve

Currently available heart valve replacements are limited in long-term performance or fail due to leaflet thickening, lack of growth or remodeling potential. In order to address these issues, it is necessary to mimic multiple factors of the native valvular extracellular matrix (ECM) such as architecture, mechanical behavior and biochemical signals. Here, we successfully generated an electrospun PEGdma–PLA scaffold adapted to the structure and mechanical properties of native valve leaflets. Valvular interstitial cells (VICs) and valvular endothelial cells (VECs) were seeded on the scaffold and when cultured under physiological conditions in a bioreactor, the construct performed like a native leaflet. Atomic force microscopy (AFM) was employed to obtain detailed mechanical information from the leaflets, which enabled the first layer-specific measurement of the Young's modulus. Interestingly, spongiosa stiffness was much lower compared to the fibrosa and ventricularis. Moreover, investigations into human fetal heart valve development identified collagen type I and versican as important structural proteins. As a proof of principle, these proteins were introduced to the scaffold, demonstrating the ability to bio-functionalize the hybrid valve based on natures' blueprint.

The BOLD Plot Thickens: Sign- and Layer-Dependent Hemodynamic Changes with Activation

In this issue of Neuron, Goense etal. (2012) report on high-resolution, layer-specific measurements of BOLD, cerebral blood volume, and cerebral blood flow in regions of positive and negative BOLD associated with a simple visual stimulus. The findings strongly suggest that the hemodynamic mechanisms behind negative signal changes are quite different from those behind positive signal changes.

Sub-micron mapping of GHz magnetic susceptibility using scanning transmission x-ray microscopy

We report submicron imaging (∼0.75 μm resolution) of complex magnetic susceptibility in a micron-size ferromagnetic heterostructure using time-resolved scanning transmission x-ray microscopy. The real and imaginary parts of the susceptibility are extracted from the phase and amplitude of the small-angle (<20°) rotational response of the local magnetization under microwave excitation. Frequency-dependent response patterns were observed in an incompletely saturated bilayer element. The technique is extensible to higher frequencies (to ∼10 GHz), better spatial resolution, and layer-specific measurement.

Responses of leaf photosynthesis, pigments and chlorophyll fluorescence within canopy position in a boreal grass (Phalaris arundinacea L.) to elevated temperature and CO<sub>2</sub> under varying water regimes

The effects of elevated growth temperature (ambient + 3.5°C) and CO2 (700 μmol mol-1) on leaf photosynthesis, pigments and chlorophyll fluorescence of a boreal perennial grass (Phalaris arundinacea L.) under different water regimes (well watered to water shortage) were investigated. Layer-specific measurements were conducted on the top (younger leaf) and low (older leaf) canopy positions of the plants after anthesis. During the early development stages, elevated temperature enhanced the maximum rate of photosynthesis (P max) of the top layer leaves and the aboveground biomass, which resulted in earlier senescence and lower photosynthesis and biomass at the later periods. At the stage of plant maturity, the content of chlorophyll (Chl), leaf nitrogen (NL), and light response of effective photochemical efficiency (ΦPSII) and electron transport rate (ETR) was significantly lower under elevated temperature than ambient temperature in leaves at both layers. CO2 enrichment enhanced the photosynthesis but led to a decline of NL and Chl content, as well as lower fluorescence parameters of ΦPSII and ETR in leaves at both layers. In addition, the down-regulation by CO2 elevation was significant at the low canopy position. Regardless of climate treatment, the water shortage had a strongly negative effect on the photosynthesis, biomass growth, and fluorescence parameters, particularly in the leaves from the low canopy position. Elevated temperature exacerbated the impact of water shortage, while CO2 enrichment slightly alleviated the drought-induced adverse effects on P max. We suggest that the light response of ΦPSII and ETR, being more sensitive to leaf-age classes, reflect the photosynthetic responses to climatic treatments and drought stress better than the fluorescence parameters under dark adaptation.

Association between myelin basic protein expression and left entorhinal cortex pre-alpha cell layer disorganization in schizophrenia

There is evidence for migrational disturbances in the entorhinal cortex (ERC) in schizophrenia that supports a neurodevelopmental origin of the disorder. Since impaired myelin basic protein (MBP) gene expression during the migration phase could lead to abnormalities in final laminar position, we performed layer specific measurements of MBP expression in the ERC and hypothesised that migrational disturbances of pre-alpha-cell clusters relate to decreased MBP expression. Paraffin embedded sections of the left entorhinal cortex of 16 schizophrenia patients and 10 control subjects were stained for MBP using routine immunohistochemistry. On each section representative regions of interest were scanned to attain optimal quality images of the gray matter. Results were correlated to previous published disturbed dispersion of pre-alpha-cell clusters in adjacent brain sections. Mean MBP stain-intensity was significantly reduced in schizophrenia patients. Absolute MBP stain-intensity was significantly reduced in layers III and IV in patients. A significant correlation of MBP stain-intensity with the distance of the deep pole of the pre-alpha-cell cluster from the gray–white matter junction was observed in the ERC of schizophrenia patients. The present data provide evidence for reduced MBP expression in the ERC in schizophrenia, which implies deficits in axonal myelination and disturbed connectivity. MBP gene is expressed in oligodendrocytes and neuronal populations during embryonic development, which are important in establishing the structure of the cerebral cortex. Correlation between reduced MBP as a sign of down-regulated MBP gene expression and disorganization of pre-alpha-cell clusters supports a neurodevelopmental origin of pathological processes in schizophrenia.

A new method for quenching correction leads to revisions of data in receptor autoradiography

Differential quenching of beta-emission affects strongly the analysis of receptor distribution patterns in quantitative receptor autoradiography with tritiated ligands. Different methods for the quenching correction have been described in the past, but some of these are of limited value, if a detailed anatomical parcellation is necessary. Other methods correct exclusively local variations in lipid concentration, which is an important, but only one of several factors causing quenching. A new method for the measurement of quenching (or autoradiographic efficiency) is presented, which permits an anatomically detailed and direct determination of the total quenching without lipid extraction procedures. This method is based on the measurement of autoradiographic efficiency in cryostat sections homogeneously labeled with tritiated formaldehyde by an underlying gelatine section containing this labeled compound. Regional and layer specific measurements of autoradiographic efficiency in cortical and subcortical regions of the human and rat brain are reported. A significant correlation was found between the density of myelin and autoradiographic efficiency but other factors were also shown to influence differential quenching. The use of the here presented correction procedure leads to revisions of the laminar distribution patterns reported for different receptors in human and rat cortical areas. Our results show, that a complete quenching correction is necessary for the mapping of receptor distributions with tritiated ligands.