Measurements made on instruments and orchestras, during the playing of selections, include average amplitudes in long intervals (15 seconds) and distribution of peaks in very short intervals (one-eighth second). Octave and half-octave bands are measured, as well as unfiltered music. The instruments tested were selected as possibly contributing extreme frequencies and amplitudes. Calculations of peak acoustic powers range as high as 27 watts. Although different techniques would be applied today, such as the use of a recorded tape to insure exact duplication of a selection as different frequency bands are explored, and the measurement of rms rather than average amplitudes, it is nevertheless felt that the measurements were reasonably accurate. The type of presentation, however, left something to be desired. Both kinds of curves will be found here in new forms. For the peaks, the plan used later in presenting similar data on speech has been adopted. The average amplitudes are reduced to a per-cycle basis in a different manner. Both types are plotted in absolute rather than relative units, and are reduced to a common distance. The table of peak powers is recalculated, using the same assumptions as before, but making the estimate for the 1 per cent level of intervals, in all cases. All new reductions and calculations are made from the original measured data. Some changes in the text are necessary to describe the revisions of the figures, and a few comments have been added. The term bar which was in current use in 1931 for dyne per square centimeter, is changed here to microbar. The Historical Note, which appeared at the end of the original paper, has been shortened somewhat and made a part of the introduction.