The effect of abrasive grit geometry on two-body abrasion wear behavior of long banana and jute fiber reinforced epoxy composites has been investigated. Epoxy (EP), Epoxy/4 wt% Banana fiber (BF)/4 wt%Jute fiber (JF) (EP8), Epoxy/8 wt%BF/8 wt%JF (EP16), Epoxy/12 wt%BF/12 wt% JF (EP24), and Epoxy/16 wt% BF/16 wt%JF (EP32) were the composite materials systems used for the investigation. These composites were processed and fabricated using hand—lay-up technique. The two body abrasion wear test was carried out in accordance with ASTM G99 under the influence of different SiC grit particles (180, 320, 400, and 600 SiC grit). The test was conducted at a room temperature under the abrasion load of 10 N and abrasion speed of 1 m s−1 over a distance of 100 m. The findings of the experiments revealed that wear response of composites depends on pressure, geometry of abrasion particles and their composition. The wear volume loss and specific wear rate decreases with increase in the rank of grit grade. Further, 16 wt% of fibers in composites exhibits the superior abrasion wear resistance. But the higher volume fraction of natural fibers in composites impaired the abrasion wear resistance. Higher rank of grit number was associated with the lesser wear volume loss because of the change in wear mechanism from abrasion to adhesion. In comparison to epoxy based composites, EP16 composite shows superior wear resistance. SEM images were used to examine the worn surfaces.