Influence Of Aerodynamic Characteristics Research Articles

Investigation of computational flow fields and aeroacoustic characteristics over a re-entry command module

Design and analysis of a wind tunnel model for re-entry vehicle configuration is a prolonged and expensive mission. As the aerothermodynamics loads acting on the vehicle are based on geometry, various wind tunnel models need to be built for aerodynamic characterization by experimental procedure. Alternatively, the intention of this article is to present the influence of aerodynamic and aero acoustic characteristics of a typical re-entry capsule by computational fluid dynamics analysis. A typical re-entry capsule is designed using computational design software and it is imported to a computational fluid dynamics solver and flow simulations are done at various input conditions. Stanford University unstructured computational fluid dynamics solver is used for this purpose to solve complex, multiphysics analysis, and optimization tasks. Computational fluid dynamics results are presented to understand the influence of aerodynamic characteristics of a typical re-entry capsule, by visualizing the flow field around the command module at all the flow regimes like subsonic, supersonic, and hypersonic flows. The flow fields are studied in detail and regions of high flow unsteadiness due to wake separated flow zone are identified. Aeroacoustic loading on the command module at these regions especially at shock wave zone are predicted in the present investigation with high order of accuracy.

Problems in creation of modern air inlet filters of power gas turbine plants in Russia and methods of their solving

The main problems in creation and operation of modern air inlet paths of gas turbine plants installed as part of combined-cycle plants in Russia are presented. It is noted that design features of air inlet filters shall be formed at the stage of the technical assignment not only considering the requirements of gas turbine plant manufacturer but also climatic conditions, local atmospheric air dustiness, and a number of other factors. The recommendations on completing of filtration system for air inlet filter of power gas turbine plants depending on the facility location are given, specific defects in design and experience in operation of imported air inlet paths are analyzed, and influence of cycle air preparation quality for gas turbine plant on value of operating expenses and cost of repair works is noted. Air treatment equipment of various manufacturers, influence of aerodynamic characteristics on operation of air inlet filters, features of filtration system operation, anti-icing system, weather canopies, and other elements of air inlet paths are considered. It is shown that nonuniformity of air flow velocity fields in clean air chamber has a negative effect on capacity and aerodynamic resistance of air inlet filter. Besides, the necessity in installation of a sufficient number of differential pressure transmitters allowing controlling state of each treatment stage not being limited to one measurement of total differential pressure in the filtration system is noted in the article. According to the results of the analysis trends and methods for modernization of available equipment for air inlet path, the importance of creation and implementation of new technologies for manufacturing of filtering elements on sites of Russia within the limits of import substitution are given, and measures on reliability improvement and energy efficiency for air inlet filter are considered.

The Influence of Aerodynamic Characteristics on Mass Exchange Efficiency in FGD Scrubbers

On the basis of the model for aerodynamic characteristics of a FGD spray tower, a model for mass exchange in a single spray bank scrubber was developed. The relation for mass transfer units with respect to parameters characterizing dispersed and continuous phases was determined. Predictions of the scrubber efficiency for very fast and very slow reaction rates in the slurry are presented and discussed. The influence of sulfur dioxide concentration in gas and slurry feeds on the absorption efficiency are shown. A qualitative comparison with experimental data presented in the literature was performed.