Indirect Selective Laser Sintering Research Articles

Direct SLS Processing for Production of Cermet Composite Turbine Sealing Components

This paper presents the development to date of Selective Laser Sintering (SLS) technologies for production of cermet composite turbine sealing components, the particular application being an abrasive blade tip. The component chosen for the application is an integral part of the low pressure turbine in a. IHPTET (Integrated High Performance Turbine Engine Technology) demonstrator engine. Both indirect and direct SLS techniques are being developed. Initial trials and process development involved the use of fugitive polymeric binders. Sequential refinements were performed to develop a binderless direct SLS process. Results from mechanical testing indicate that acceptable microstructure and properties are attainable by SLS with substantial cost savings as compared to the currently employed production method. This is the first instance of direct Solid Freeform Fabrication (SIT) method applied to a functional component.

Behaviour of a powder/binder system — moulding and thermal debinding: J.C. Moller, D. Lee (Rennselaer Polytechnic Inst., Troy, New York, USA), Int J Powder Metallurgy, Vol 30, No 1, 1994, 103–114.

Complex-shaped porous Al2O3 ceramics with spontaneously formed pores and enhanced strength were prepared by indirect selective laser sintering (SLS) combined with reaction bonding (RB) using Al2O3, Al and epoxy resin E12 mixed powders as raw materials. The influence of the Al amount (0–32.5 wt%) on microstructure, dimensional change, porosity, pore size distribution and bending strength of sintered bulks were investigated. The phase transition, pore structure evolution and strength enhancement mechanisms of porous ceramics with Al addition were analyzed. Owing to distinctive characteristics of Al oxidation in the RB process, including volume expansion during oxidation, spontaneously formed pores and improved bonding force, the change rate in dimension was reduced, the porosity was maintained and bending strength was enhanced, compared with the case of adding only organic binders. The sintered bulks with the Al addition of 22.5 wt% had a dimensional change of <0.99%, porosity of 54.5 ± 0.2% and maximum bending strength of 10.8 ± 0.6 MPa, which was 6.8 times as that of samples with no Al addition. The findings illustrate that understanding pore structure evolution and strength enhancement mechanisms will help design high-performance porous Al2O3 ceramics prepared by powder-based additive manufacturing.