Quantification of HIV-1 viral RNA based on co-amplification of an internal standard Q-RNA dilution series requires a number of NASBA nucleic acid amplification reactions. For each internal standard Q-RNA concentration a separate NASBA amplification has to be performed. The development of an electrochemiluminescent (ECL) detection system with a dynamic signal detection range over 5 orders of magnitude enabled simplification of the Q-NASBA protocol. Three distinguishable Q-RNAs (Q A, Q B and Q c) are mixed with the wild-type sample at different amounts (i.e. 10 4 Q A, 10 3 Q B and 10 2 Q c molecules) and co-amplified with the wild-type RNA in one tube. Using ECL-labelled oligonucleotides the wild-type, Q A, Q B and Q c amplificates are separately detected with a semi-automated ECL detection instrument and the ratio of the signals determined. The amount of initial wild-type RNA can be calculated from the ratio of wild-type signal to Q A, Q B and Q c signals. This one-tube Q-NASBA protocol was compared to the earlier described protocol with six amplifications per quantification using model systems and HIV-1 RNA isolated from plasma of HIV-1-infected individuals. In all cases the quantification results of HIV-1 RNA were comparable between the two methods tested. Due to the use of only one amplification per quantification in the one-tube Q-NASBA protocol the Q A, Q B and Q c internal standard RNA molecules can be added to the sample before nucleic acid isolation. The ratio of Q A : Q b : Q c : WT RNAs, from which the initial input of WT-RNA is calculated, will remain constant independent of any loss that might occur during the nucleic acid isolation.