Higher T50 Research Articles

Effect of Carbopol and polyvinylpyrrolidone on the mechanical, rheological, and release properties of bioadhesive polyethylene glycol gels.

This study examined the mechanical (hardness, compressibility, adhesiveness, and cohesiveness) and rheological (zero-rate viscosity and thixotropy) properties of polyethylene glycol (PEG) gels that contain different ratios of Carbopol 934P (CP) and polyvinylpyrrolidone K90 (PVP). Mechanical properties were examined using a texture analyzer (TA-XT2), and rheological properties were examined using a rheometer (Rheomat 115A). In addition, lidocaine release from gels was evaluated using a release apparatus simulating the buccal condition. The results indicated that an increase in CP concentration significantly increased gel compressibility, hardness, and adhesiveness, factors that affect ease of gel removal from container, ease of gel application onto mucosal membrane, and gel bioadhesion. However, CP concentration was negatively correlated with gel cohesiveness, a factor representing structural reformation. In contrast, PVP concentration was negatively correlated with gel hardness and compressibility, but positively correlated with gel cohesiveness. All PEG gels exhibited pseudoplastic flow with thixotropy, indicating a general loss of consistency with increased shearing stress. Drug release T50% was affected by the flow rate of the simulated saliva solution. A reduction in the flow rate caused a slower drug release and hence a higher T50% value. In addition, drug release was significantly reduced as the concentrations of CP and PVP increased because of the increase in zero-rate viscosity of the gels. Response surfaces and contour plots of the dependent variables further substantiated that various combinations of CP and PVP in the PEG gels offered a wide range of mechanical, rheological, and drug-release characteristics. A combination of CP and PVP with complementary physical properties resulted in a prolonged buccal drug delivery.

Neutrophil passage through isolated perfused rabbit lungs

Kinetics of polymorphonuclear leukocyte (PMN) lung passage were investigated in ex vivo isolated and ventilated left rabbit lungs, perfused with buffer solution at physiological flow rate. 111In-labeled PMNs of rabbit or human origin were injected into the pulmonary artery, and the first fraction of PMNs that rapidly passed the lung together with coinjected erythrocytes, was collected separately for external radioactivity counting. Washout of initially retained PMNs from the lung was monitored by use of a sodium-iodide detector. Recirculation of cells was avoided by insertion of a filter in the perfusion circuit. A fraction of 16.6 +/- 1.3% of rabbit PMNs rapidly passed the lung vasculature, followed by an exponential washout of initially retained PMNs [half-time (t50) of lung transit 8.1 +/- 0.6 min]. Slightly higher t50 (12.2 +/- 1.0 min) was obtained upon use of human PMNs. Reduction in flow by 50% caused a marked prolongation of PMN transit (t50 = 27.8 +/- 5.1 min), whereas increase in flow to 150% only insignificantly decreased t50. Rise in pulmonary venous pressure to 5 and 8 mmHg caused retardation of PMN lung transit (t50 = 15.3 +/- 0.6 and 31.6 +/- 3.6 min). Preincubation of PMNs with 2 ng/ml endotoxin for 1 h induced marked delay in PMN washout (t50 = 26.1 +/- 2.8 min). In conclusion, single-pass PMN kinetics in isolated lungs correspond to in vivo studies previously reported, thus allowing elucidation of PMN-endothelial interactions in an intact lung vasculature under standardized conditions.