This paper evaluates the anisotropic stress corrosion cracking behaviour of high-strength prestressing steel wires. To this end, two eutectoid steels in the form of hot rolled bar and cold drawn wire were subjected to stress corrosion cracking tests in aqueous environments using a constant strain technique and precracked three point bend specimens to measure the crack growth rate da/dt as a function of the stress intensity factor KI under hydrogen embrittlement environmental conditions (pH = 12.5 E = − 1200 mV SCE). While the hot rolled bar presents an isotropic stress corrosion cracking behaviour associated with mode I crack growth, the cold drawn wire exhibits a change in crack propagation direction approaching that of the wire axis (cold drawing direction) and producing mixed mode crack growth. This anisotropic stress corrosion cracking behaviour is a consequence of manufacturing, since cold drawing affects the microstructure of the material and produces a preferential orientation of the pearlite lamellae aligned parallel to the wire axis. The differences of crack growth rate as a function of the crack propagation direction are discussed. Anisoptropes Spannungsrißkorrosionsverhalten von Spannstahl Die Arbeit beurteilt das anisotrope Spannungsrißkorrosionsverhalten von hochfesten Spannstahldrähten. Zu diesem Zweck wurden zwei eutektoide Stähle in Form warmgewalzter Stäbe bzw. kaltgezogener Drähte Spannungsrißkorrosionsversuchen in wäßrigen Umgebungen ausgesetzt und mit Hilfe der konstanten Dehntechnik und angerissener 3-Punkt-Biegeproben wurde die Rißwachstumsgeschwindigkeit da/dt als Funktion des Spannungsintensitätsfaktor KI unter Umgebungsbedingungen, die zur Wasserstoffversprödung führen (pH = 12,5, E = − 1200 mV SCE), gemessen. Während der warmgewalzte Stab ein isotropes Spannungsrißkorrosionsverhalten, verbunden mit Rißwachstum nach Modus I, zeigte, erfuhr der kaltgezogene Draht eine Änderung der Rißfortpflanzungsrichtung, die sich der Drahtachse annäherte (Richtung des Kaltziehens), und erzeugte ein Rißwachstum mit gemischtem Modus. Dieses anisotrope Spannungsrißkorrosionsverhalten ist eine Folge der Herstellung, da das Kaltziehen das Gefühge des Werkstoffes beeinflußt und eine bevorzugte Orientierung der Perlitlamellen parallel zur Drahtachse bewirkt. Die Unterschiede der Rißwachstumsgeschwindigkeit als eine Funktion der Rißfortpflanzungsrichtung werden diskutiert.