Drying front propagation and coupled heat and mass transfer analysis from porous media is critical for soil-water dynamics, electronics cooling, and evaporative drying. In this study, de-ionized water was evaporated from three 3D printed porous structures (with 0.41 mm, 0.41 mm, and 0.16 mm effective radii, respectively) created out of acrylonitrile butadiene styrene (ABS) plastic using stereolithography technology. The structures were immersed in water until all the pores were invaded and then placed on the top of a sensitive scale to record evaporative mass loss. A 1000 W/m2 heat flux was applied with a solar simulator to the top of each structure to accelerate evaporation. The evaporative mass losses were recorded at 15 min time intervals and plotted against time to compare evaporation rates from the three structures. The evaporation phenomena were captured with a high-speed camera from the side of the structures to observe the drying front propagation during evaporation, and a high-resolution thermal camera was used to capture images to visualize the thermal gradients during evaporation. The 3D-structure with the smallest effective pore radius (i.e., 0.16 mm) experienced the sharpest decrease in the mass loss as the water evaporated from 0.8 g to 0.1 g within 180 min. The designed pore structures influenced hydraulic linkages, and therefore, evaporation processes. A coupled heat-and-mass-transfer model modeled constant rate evaporation, and the falling rate period was modeled through the normalized evaporation rate.