The aim of this study was to investigate optimal loading doses prior to continuous infusion of meropenem in critically ill patients. A previously published and successfully evaluated pharmacokinetic model of critically ill patients was used for stochastic simulations of virtual patients. Maintenance doses administered as continuous infusion of 1.5–6 g/24 h with preceding loading doses (administered as 30 min infusion) of 0.15–2 g were investigated. In addition to the examination of the influence of individual covariates, a best-case and worst-case scenario were simulated. Dosing regimens were considered adequate if the 5th percentile of the concentration–time profile did not drop at any time below four times the S/I breakpoint (= 2 mg/L) of Pseudomonas aeruginosa according to the EUCAST definition. Low albumin concentrations, high body weight and high creatinine clearances increased the required loading dose. A maximum loading dose of 0.33 g resulted in sufficient plasma concentrations when only one covariate showed extreme values. If all three covariates showed extreme values (= worst-case scenario), a loading dose of 0.5 g was necessary. Higher loading doses did not lead to further improvements of target attainment. We recommend the administration of a loading dose of 0.5 g meropenem over 30 min immediately followed by continuous infusion.