Results from state of Washington Occupational Safety and Health Administration (OSHA) health inspections were reviewed to characterize the level of control that existed at the work sites, identify common problems, and assess the success of targeting programs in finding and correcting uncontrolled health hazards. Data were obtained from 170 inspections conducted by industrial hygienists in a four-county area in 12 industries, including 10 that were targeted. Inspection data were accessed through the use of electronic databases and inspection reports then summarized by the following industries: bathtub refinishing, carbide tool and saw sharpening, fibercement siding installation, furniture refinishing, health care clinics, janitorial floor waxing service, landscaping, lawn maintenance, tree service, road construction, stone countertop fabrication, truck bed lining, warehouse and cold storage, and wood floor finishing. Targeted health hazards included worker exposure to airborne contaminants, noise, and bloodborne pathogens typical of the industry. Method and effectiveness of control of health hazards were evaluated by counting work sites with violations associated with engineering control, personal protective equipment, hearing conservation, or training. Results are presented by industry for the number and percentage of work sites that failed to provide required protection. Poor control of health hazards was generally found across all inspected industries. Follow-up inspections and self-reports of abatement found that more than 85% were able to successfully control the hazards and abate the violations. The results are further discussed as they relate to methods of control and risk and identifying existing and emerging high health hazard industries. Based on employment data and the poor hazard control that was found, most if not all the industries can be described as high health hazard, small-employer industries. The results can be used for the planning of interventions in other regions and industries.