This paper deals about the quality improvement in Raw Mill – 2. In order to increase the efficiency of production and greater quality of cement, table feeder is replaced with weigh belt feeder. The weight belt feeder helps to weigh the amount of raw material composition and to maintain the constant TPH which is feed to the raw mill. This load cell transfer electrical signals to the electronic unit which is proportional to the load pressure exerted by the raw material. The replacement of existing coin burner with multi channel burner result in increased clinker quality. It is observed that the flame geometry is improved with new burner. Also there is enhanced nodulization and improved strength. Hence a thorough investigation was done on the problems relating to raw mill – 2 and quality improvement is carried out. This dissertation work reports the successful completion and implementation of the same.