THE lecturer began by a reference to the work of John Hopkinson, and to his own early work on the perfecting of standards of length. His first experiments were on nickel, which had two great advantages over brass for metrological work, viz. its smaller coefficientof expansion and its greater freedom from corrosion. He would probably not have looked further but for the difficulty at the time of getting large bars of the material free from flaws. In investigating the ferro-nickel alloys, his first experiments were on their magnetic propercies, as these were easier to investigate than the coefficients of expansion. Dr. Guillaume showed and explained curves representing the variation of magnetic properties, andof the co efficients α and β in the expansion equation l = l0(I + αθ + βθ2) for alloys in both the irreversible and reversible categories, and showed from the curves how it was possible to obtain alloys with any desired coefficient. The anomalous magnetic behaviour of some of the alloys was illustrated by demonstration experiments of the effect produced on the magnetic condition of bars of the materials by dipping in hot water or liquid air. The lecturer then dealt with the properties of ternary alloys containing iron, nickel, and a third element. Manganese alloys were those most extensively used. He exhibited a cardboard model of Guthrie's three-dimensional diagram, for ternary alloys. The addition of the third element raised the minimum expansion. In the case of carbon and chromium the elastic constant israised. The curve connecting Young's modulus with the percentage of nickel in ferro-nickel alloys also showed an anomaly in the same region as the expansion.