Family Of Resonant Converters Research Articles

A Design Procedure and Control Method for Improving Efficiency of a Family of Resonant Converters over Wide Operating Conditions

A Design Procedure and Control Method for Improving Efficiency of a Family of Resonant Converters over Wide Operating Conditions

An LLC Converter Family With Auxiliary Switch for Hold-Up Mode Operation

This paper proposed a new half-bridge (HB) LLC resonant converter family with pulse-width modulated (PWM) auxiliary switch (sLLC converter) for hold-up mode operation. The proposed sLLC converters could operate with synchronous rectifier, which is suitable for low-output voltage applications. In the proposed converters, an auxiliary switch is added at the primary side to provide charging path for the series resonant inductor. For nominal 400-V input, sLLC achieves same performance as conventional LLC converter, and all the good features such as soft switching are naturally retained. For slight input voltage fluctuation, frequency modulation is used to regulate the output voltage. When the input voltage reduces further, HB switches will operate at constant minimum frequency, and the auxiliary switch will operate in the PWM mode to energize the resonant inductor with the bus voltage directly during hold-up period. Thus, the converter achieves higher voltage gain, and the output voltage can be maintained at desired level. To verify the effectiveness of the proposed sLLC converter, operational principle and equivalent circuits will be carefully explained and analyzed in this paper. A 300-W prototype is built for 250–400-V input 12-V output application.

Control features of dual-channel DC-DC converters

This paper presents the steady-state behavior of a two-channel resonant converter family in symmetrical operation. Six configurations will be investigated, including step-down, step-up/down, and step-up ones in continuous conduction mode (CCM) and in discontinuous conduction mode (DCM). Exploring the conditions of transition from CCM to DCM or back, it becomes evident that the CCM operation is definitely restricted, that is, sometimes the converter cannot he operated in CCM at all. The most important relations among the input, output, and control variables are derived and verified by simulation and experimental results.

A capacitor charging power supply utilizing a Ward converter

A prototype capacitor-charging power supply (CCPS) that utilizes a Ward converter is presented. This converter is a member of the family of resonant converters and is capable of zero-current switching. It is applicable to capacitor charging because of its inherent short-circuit protection and its insensitivity to the value of the load capacitance. The converter is controlled using a constant on-time constant frequency scheme that allows the utilization of zero-current switching techniques. The prototype CCPS is capable of charging various values of load capacitors up to 1000 V DC. Waveforms that show single- and repetitive-charge operation of the CCPS are presented. >

A new method to regulate resonant converters

A resonant frequency-modulation method is presented as an alternative to the switching frequency-modulation method to regulate resonant converters. A switch-controlled inductor and switch-controlled capacitor, in which switching losses are found to be very low due to zero-current or zero-voltage switching, are developed to do so. A new family of resonant converters that are regulated at a fixed switching frequency is proposed. A steady-state analysis of the Class E resonant converter regulated by a switch-controlled capacitor is presented. Theoretical and experimental results verify the validity of the proposed method. The efficiency measured from a breadboard of 1 MHz, 5 V, 25 W Class E regulated resonant DC-DC converter is up to 83%.< <ETX xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">&gt;</ETX>