Extra-articular Distal Radial Fractures Research Articles

Casting versus percutaneous pinning for extra-articular fractures of the distal radius in an elderly chinese population: a prospective randomised controlled trial

We carried out a prospective randomised controlled clinical trial to compare the functional and radiological outcomes of casting with percutaneous pinning in treating extra-articular distal radial fracture in an elderly Chinese population. Sixty patients were randomly allocated by sealed envelopes to either a 'Cast' group (n = 30) or a 'K-wire' group (n = 30). All patients were available for final follow-up assessment. The radiological outcomes in terms of dorsal angulation, radial inclination and radial length were statistically significantly better in the K-wire group, whereas the Mayo wrist score and quality of life, healing rate, healing time, and complications were similar. The functional outcomes and quality of life were not affected by the treatments. Both treatments had a very low rate of complication and high healing rates.

Volar locking plates versus Kirschner wires for distal radial fractures—A cost analysis study

Background There is an increasing trend for managing dorsally angulated distal radial fractures with locked volar plate fixation in fractures that may have previously been managed with percutaneous Kirschner wire (K-wire) fixation. There has been no prospective randomised trial comparing locked volar plate fixation with percutaneous K-wire fixation. In the absence of data guiding management with regard to clinical effectiveness, we have examined the cost of each technique. Methods Patients’ details were collected retrospectively between June 2007 and June 2008. Ten consecutive patients who underwent percutaneous K-wire fixation for a distal radius fracture and the 10 who were treated by locked volar plate fixation were identified and their hospital notes retrieved. All patients had a closed extra-articular distal radial fracture with dorsal angulation. The duration and type of operation, including number of wires or screws used, were recorded. Results The mean age of the patients was 54 years for the locking plate group and 34 years for the percutaneous K-wire group. The mean time taken to perform percutaneous K-wire fixation with an average of two K-wires was 56 min. The mean time for applying a volar locked plate was 121 min. The cost of a pack of 10 K-wires was £3. The total cost of a standard volar locking plate and screws used was £787. Discussion In the absence of research comparing clinical end points, cost must play a major factor in determining the type of operation offered. A 56-min operation to percutaneously fix a distal radial fracture with K-wires costs £662. This compares to a cost of £2212 for a 121-min locked volar plate fixation. There is a calculated difference of £1549 and 65 min. Conclusion With use of a locked volar plate for patients under the age of 70 years there is a loss of £652 for the Trust with the present NHS tariffs.

Reliability of a digital radiographic system in measuring distal radial fracture displacement parameters

Digital imaging systems have been introduced recently. We prospectively investigated the accuracy of fracture displacement measurements using digital imaging. Ten consecutive adult extra-articular distal radial fractures were chosen. Five consultants and five registrars measured pre-reduction and post-reduction radial height, radial inclination and radial tilt. Measurements were repeated after 1-week. Interobserver and intraobserver reliability were measured and compared with previous studies which used plain X-ray. We calculated intraclass correlation coefficient to assess reliability and tolerance limit. All the parameters showed improved inter and intra-rater reliability compared to reported results with plain X-rays. Interrarater reliability for radial height was 0.545–0.644 and intrarater reliability was 0.550–0.647, tolerance limit was ±3.49 to ±5.47 mm. Radial inclination values were 0.535–0.624, 0.536–0.626, ±3.50° to ±7.06°. Radial tilt values were 0.539–0.889, 0.544–0.889, ±3.81° to ±7.71° respectively. We found new digital imaging more reliable in measuring distal radial fracture displacement parameters.

Internal Fixation of Dorsally Displaced Fractures of the Distal Part of the Radius

Volar plate fixation with use of either a locking plate or a neutralization plate has become increasingly popular among surgeons for the treatment of dorsally comminuted extra-articular distal radial fractures. The purpose of the present study was to compare the relative stability of five distal radial plates (four volar and one dorsal), all of which are commonly used for the treatment of dorsally comminuted extra-articular distal radial fractures, under loading conditions simulating the physiologic forces that are experienced during early active rehabilitation. With use of a previously validated Sawbones fracture model, a dorsally comminuted extra-articular distal radial fracture was created. The fracture fixation stability of four volar plates (an AO T-plate, an AO 3.5-mm small-fragment plate, an AO 3.5-mm small-fragment locking plate, and the Hand Innovations DVR locking plate) were compared under axial compression loading and dorsal and volar bending simulating the in vivo stresses that are generated at the fracture site during early unopposed active motion of the wrist and digits. A single dorsal plate (an AO pi plate) was used for comparison, with and without simulated volar cortical comminution. The construct stiffness was measured to assess the resistance to fracture gap motion, and comparisons were made among the implants. The volar AO locking and DVR plates had greater resistance to fracture gap motion (greater stiffness) compared with the volar AO nonlocking and AO T-plates under axial and dorsal loading conditions (p < 0.01), with no significant difference between the AO volar locking and DVR plates. The volar AO locking plate had greater resistance to fracture gap motion than did the volar AO nonlocking plate under axial loading and dorsal bending forces (p < 0.01). The dorsal pi plate had the greatest resistance to fracture gap motion under axial loading and volar and dorsal bending forces (p < 0.01). However, the pi plate was significantly less stable to axial load and dorsal bending forces when the volar cortex was comminuted (p < 0.01). In this model of dorsally comminuted extra-articular distal radial fractures, dorsal pi-plate fixation demonstrated better resistance to fracture gap motion than did the four types of volar plate fixation. The AO volar locking and DVR plates conferred the greatest resistance to fracture gap motion among the four volar plates tested. Volar locking technology conferred a significant increase in resistance to fracture gap motion as compared with nonlocking plate technology.

A traction jig for reduction of distal radial fractures

A traction jig is described which facilitates the closed reduction of extra-articular distal radial fractures and which maintains the reduction whilst a plaster cast is applied. The jig is suitable for use by a single operator in an Accident and Emergency department setting.

Closed reduction versus Kapandji-pinning for extra-articular distal radial fractures

In a randomized prospective trial, treatment of extra-articular distal radial fractures by closed reduction and plaster application was compared with Kapandji-pinning. Closed reduction and plaster cast was used in 50 patients, Kapandji-pinning in 48 patients. According to the Cooney score, good and excellent results were found in the closed reduction and plaster cast group in 74%, compared with 75% in the Kapandji-pinning group. After measuring the maintenance of reduction as well as the functional outcome at 1 year follow-up, no statistically significant differences could be found between the two groups. We conclude that both techniques can be used in treating extra-articular fractures of the distal radius.

Arthroscopic diagnosis of intra-articular soft tissue injuries associated with distal radial fractures

Arthroscopy was used to assess the soft tissue injuries associated with distal radial fractures in 118 acute intra- and extra-articular fractures. The triangular fibrocartilage complex (TFCC) was torn in 46 of 118 patients--in 35% of intra-articular fractures and in 53% of extra-articular fractures. No correlation between ulnar styloid fractures and TFCC injuries could be found. Scapholunate (SL) ligament injuries with instability were present in 21.5% of intra-articular fractures and in 6.7% of extra-articular fractures. Lunotriquetral (LT) ligament injuries with instability were present in 6.7% of intra-articular fractures. and in 13.3% of extra-articular fractures. Combined SL and LT injuries were present in 5.6% of intra-articular fracture. Preoperative radiographs correlated with TFCC injury. Patients with TFCC tears had greater shortening and dorsal angulation on the preoperative radiographs. Preoperative radiographs had no predictive value for interosseous ligament injury. Ligamentous injuries are commonly associated with both intra-articular and extra-articular distal radial fractures.

Fractures of the distal radius and scaphoid

Simultaneous fractures of the distal radius and scaphoid is an uncommon wrist injury. During the period 1980 to 1993, 23 patients with a median age of 39 years were treated for this injury. The median follow-up period was 7 years. All scaphoid fractures were undisplaced and located in the waist or distal third. An extraarticular distal radial fracture was observed in 15 wrists. A below elbow cast including the thumb was applied in 18 wrists for a mean duration of 9 weeks, and operative treatment was used in only 5 patients. All scaphoid fractures healed without complications. During conservative treatment there were three redisplacements of distal radial fractures. The final functional results were good in 18, fair in four, and poor in one patient. Because complications occurred at the distal radius we have changed our conservative treatment policy from a below elbow cast including the thumb to a dorsal splint for 6 weeks.