Mechanically polished zirconium electrodes were potentiodynamically polarized in phosphate buffer solutions of various pH values and in 0.5 lvl NaOH. The results show that the shape of the I-E curves is independent of the solution pH. At relatively low scan rates, oxygen gas evolution was observed. The oxide film thickness was calculated from the values of the charge consumed in the anodic process assuming 100% current efficiency for oxide formation below oxygen evolution (lower values for the current efficiency are assumed for potentials above oxygen evolution). Capacitance measurements, together with the calculated oxide thickness, were used to estimate values for the dielectric constant of the oxide. Two different values of the dielectric constant were obtained for the oxides formed in the range of potential below and above oxygen evolution. Also, higher dielectric constant values were obtained with increasing solution pH. Anion incorporation was assumed to increase the conductivity of the oxide films and, hence, decrease the dielectric constant. A two-layer structure is proposed for the anodically formed oxide on zirconium in aqueous solutions; an anion-free layer near the metal and an outer layer containing the incorporated anions.