Estimates Of Ground-level Concentrations Research Articles

Dispersion of pollutants over land–water–land interface: Study using CALPUFF model

The CALMET/CALPUFF modeling system is used to study atmospheric dispersion of pollutant over land–water–land interface. It is shown that the default scheme used by CALMET/CALPUFF to handle inhomogeneous surfaces does not take care of the different turbulence characteristics over such surfaces. An alternative method is suggested to incorporate different turbulent characteristics over inhomogeneous surfaces by using the appropriate atmospheric stability category over different surfaces. The results show that the presence of water body can increase the ground level concentration by a factor of up to 50 for the width of water body varying from 1 km to 5 km. It is also shown that the effect of water body on the ground level concentration decreases as the distance from the water body increases. The present study showed that for land–water interface, the realistic specification of turbulence characteristics over inhomogeneous surfaces significantly changes the estimation of ground level concentration as compared to the default scheme available in the CALMET/CALPUFF modeling system and is expected to give realistic results.

Building wake dispersion at an Arctic industrial site: Field tracer observations and plume model evaluations

Ten multi-hour atmospheric dispersion SF 6 tracer experiments were conducted during October and November of 1987 near a large oil gathering facility in the Prudhoe Bay, Alaska, oilfield reservation. The purpose of this study was to investigate dispersion under arctic conditions and in situations where building-generated airflow disturbances dominate downwind distributions of ground level pollutant concentrations. This was accomplished with a network of micrometeorological instruments, portable syringe tracer samplers, continuous tracer analyzers, and infrared visualization of near source plume behavior. Atmospheric stability and wind speed profiles at this arctic site are influenced by the smooth (surface roughness = 0.03 cm), snow covered tundra surface which receives negligible levels of solar isolation in winter. The dispersion of pollutants emitted from sources within the oil gathering facility, however, is dominated by the influence of nearby buildings when high winds generate elevated ground level concentrations. An order of magnitude increase in maximum ground level concentration was observed as wind speeds increased from 5 to 8 m s −1 and another order of magnitude increase was observed as winds increased from 8 to 16 m s −1. Variation in maximum concentrations was also observed with changes in wind direction. Vertical plume diffusion ( σ z ) near the buildings was a factor of 2–3 greater than that observed in open terrain and was dependent on both wind speed and the projected building width and location of nearby buildings. Wind tunnel tracer distributions for east winds agree with field observations but also indicate that a significant increase in plume downwash occurs with other wind directions. Concentration distributions were calculated using several versions of the Industrial Source Complex (ISC) model. Model estimates of ground level concentrations were within a factor of three depending on wind direction. The model predictions are extremely sensitive to the ratio of plume height to vertical plume diffusion which is significantly influenced by a complex aerodynamic wake in the field.

Turbulent dispersion in a stable layer with a quadratic exchange coefficient

Dispersion from a line source into a stable boundary layer of thickness l is analysed through solution of the diffusion equation assuming an exchange coefficient K(z) ∫ (1 − z/l)2 and wind profiles u(z) ∫ zn, with n = 0,1. Estimates of ground-level concentrations are made by developing analytic formulae where this is possible. A general method of solution using Laplace transformation and Green's function techniques is developed as an alternative to the eigenfunction expansion method discussed previously (Robson, 1983).

Estimation of downwind viable airborne microbes from a wet cooling tower—Including settling

In recent years, reuse of municipal waste water as the coolant in drift-producing cooling towers at electrical generating plants has become increasingly common. A hueristic model is presented that can be used to estimate the concentrations of viable airborne microbes in the drift from a wet cooling tower given the concentration of microbes in the cooling tower. The purpose of this presentation is to allow the nonmeteorologist to understand the factors affecting airborne concentration and to make crude estimates of ground-level concentrations of airborne microorganisms. Concentrations are calculated using a standard meterological method, the Gaussian dispersion model, in which terms have been included for droplet settling and microbial death rate.