ABSTRACT In this work, end of life tyres (ELTs) samples were subjected to pyrolysis in a dynamic thermogravimetry set-up under various heating rates between 5°C and 25°C min−1. The experimental design involved dried and non-dried sample results in an isothermal step within the heating program, to be able to compare the data against non-dried samples, to further investigate the effect of drying on the results obtained. The drying of the samples resulted in an increase in the onset temperature by some 30°C. However, cryomilling the ELTs samples showed a great effect in reducing the onset of the degradation curve by about 10°C amongst the same set of experiments. The type of sample, in terms of size and processing/milling condition, had a significant impact on the heat flow properties and calorimetry reported. The exothermic region for the original shavings resulted in an enthalpy of −48 J g−1, whilst the cutting mill samples exhibited an enthalpy increase to −184 J g−1. However, the cryomilled samples showed an enthalpy increase estimated at 139 J g−1.