The goal of our research is to build upon the capability of RELAP5-3D to model molten lead systems. Molten lead has several potential uses in future advanced reactors, like the lead fast reactor or fusion reactors that utilize dual-coolant lead lithium blankets. This potential for use in future generations of reactors highlights the necessity of developing molten lead models to ensure that they can accurately predict thermohydraulic behavior. We have developed a RELAP5-3D model of the Lobo Lead Loop facility located at the University of New Mexico to verify the accuracy of RELAP5-3D via comparison to existing computational fluid dynamics results and analytical calculations. It was found that RELAP5-3D accurately calculated radiative heat transfer (within <1%) when compared to theoretical calculations. In addition, pressure drop calculations done in RELAP5-3D demonstrated reasonable agreement within 20 kPa, mostly within ~7% to 15%, when compared to the computational fluid dynamics model of the facility developed by the University of New Mexico, and captured the dependence of pressure drop on flow velocity accurately. Finally, a hypothetical loss-of-flow transient was imposed on the RELAP5-3D model to determine the feasibility of performing a similar experiment with the Lobo Lead Loop. It was found that such an experiment could be possible, as the RELAP5-3D model indicated that the temperatures of the fluid would not exceed the limiting temperatures of the structure (1658 K) nor the maximum temperature of the electromagnetic pump inlet (823 K). Although there are no experimental data to begin validation, the model will be readily available for future validation studies when the experimental data are generated, especially as the model continues to evolve over time. The results so far demonstrate a promising first step in the verification/validation of the RELAP5-3D model of the Lobo Lead Loop. The highlights from our research are as follows: 1. The Lobo Lead Loop facility at the University of New Mexico is a good candidate for molten lead system code validation. 2. The Lobo Lead Loop currently has extensive pressure drop results from a high-fidelity computational fluid dynamics model, which offers the opportunity for code-to-code verification of pressure drop in RELAP5-3D. 3. A RELAP5-3D model of the Lobo Lead Loop has been developed to begin verification studies and to prepare for potential validation studies. 4. Development of the model will continue throughout the future to prepare for potential validation studies.
Read full abstract