Doppler Strain Rate Imaging Research Articles

Endomyocardial radial strain rate imaging during dobutamine stress echocardiography for the evaluation of contractile reserve in patients with dilated cardiomyopathy.

Myocardial contractile reserve is associated with clinical prognosis in patients with dilated cardiomyopathy (DCM). We assessed myocardial contractile reserve using tissue Doppler strain rate imaging with dobutamine stress echocardiography in DCM patients. Simultaneous echocardiography and left ventricular (LV) catheterization during dobutamine stress were performed in 20 patients with DCM, and echocardiography was performed in 31 control subjects. Dobutamine was infused at a starting dose of 5 μg/kg/min for 5 minutes and then at 10 μg/kg/min. Peak endomyocardial radial strain (ɛ) and systolic strain rate (SRsys ) measured with echocardiography and the maximum first derivative of LV pressure (LV dP/dtmax ) derived from catheterization were used as indices of contractility. Their percentage change from baseline to the dose of 10 μg/kg/min was calculated. The ɛ and SRsys were significantly smaller in DCM patients than in controls. The LV dP/dtmax , ɛ, and SRsys were significantly higher at the dose of 10 μg/kg/min than at baseline. The percentage change in SRsys was significantly correlated with the percentage change in LV dP/dtmax . Strain rate imaging during dobutamine stress in DCM might prove noninvasively informative for the evaluation of myocardial contractile reserve and provide insight into LV systolic dysfunction. © 2016 Wiley Periodicals, Inc. J Clin Ultrasound 44:555-560, 2016.

Impact of Preserved Myocardial Contractile Function in the Segments Attached to the Papillary Muscles on Reduction in Functional Mitral Regurgitation

Effectiveness of functional mitral regurgitation (FMR) in heart failure patients is of growing importance for patient prognosis. The purpose of this study was to investigate whether regional myocardial contractile function as assessed by tissue Doppler strain rate imaging can predict reduction in FMR caused by dobutamine. Fifty-one patients with depressed left ventricular (LV) ejection fraction (32±9%) secondary to dilated cardiomyopathy and FMR underwent evaluation of effective regurgitant orifice (ERO) of FMR, mitral valve deformation, global LV remodeling, and regional myocardial contractile function assessed by longitudinal peak systolic strain rate (Ssr) in 6 mid-LV segments from standard apical views. We also determined the average Ssr of segments attached to the papillary muscles, that is, the inferior, inferolateral, and anterolateral segments (PM segments Ssr). Low-dose (10μg/kg per minute) dobutamine-induced reduction in ERO was compared with baseline variables. Baseline valve tenting was associated with dobutamine-induced reduction in ERO (r=-0.30, P<0.05). Receiver operating characteristic curve analysis showed that baseline valve tenting, LV sphericity index, inferior Ssr, inferolateral Ssr, and PM segments Ssr were predictors of dobutamine-induced ≥30% reduction in ERO. Importantly, only PM segments Ssr predicted dobutamine-induced ≥20% reduction in valve tenting with area under the curve of 0.67 (P<0.05). Preserved myocardial contractile function in the segments attached to the PMs was associated with dobutamine-induced reduction in mitral valve tenting and FMR, suggesting that our findings are important for improvement in cardiac function and FMR with medical treatment.

Assessment of atrial contractile properties with a color doppler strain rate imaging in patients with paroxysmal atrial fibrillation

Assessment of atrial contractile properties with a color doppler strain rate imaging in patients with paroxysmal atrial fibrillation

Role of Left Ventricular Regional Diastolic Abnormalities for Global Diastolic Dysfunction in Patients with Hypertrophic Cardiomyopathy

The usefulness of Doppler strain rate imaging for assessment of left ventricular regional diastolic function has not been fully determined. We aimed to clarify the relationships between diastolic strain rates and global diastolic function and find a useful index for regional diastolic function in patients with hypertrophic cardiomyopathy (HCM). Strain rate curves were obtained using an apical approach at 12 different sites of the left ventricular myocardium in 25 patients with HCM and 20 control subjects, and peak early diastolic strain rate (ESR), peak late diastolic strain rate, and the time from QRS to ESR were measured. The flow propagation velocity was measured using color M-mode Doppler echocardiography as a global diastolic index. Each of the spatially averaged values of ESR and ESR/peak late diastolic strain rate and the coefficients of variation of time from QRS to ESR was significantly correlated with flow propagation velocity, but the best correlation was observed in ESR. Although both ESR and peak late diastolic strain rate of each myocardial segment of patients with HCM tended to decrease as the wall thickness increased, only ESR significantly decreased even in the segments without apparent hypertrophy. In patients with HCM, the reduction of ESR was more closely associated with global diastolic dysfunction than asynchrony, and ESR may be a useful and sensitive index for regional diastolic function.

Radial Strain Gradient Across the Normal Myocardial Wall in Open-chest Pigs Measured with Doppler Strain Rate Imaging

One of the reasons for the large variation in radial strain measured with Doppler strain rate imaging in normal myocardium might be the different strain length (SL) used during analyses. The aim of this study was to evaluate the effect of different SL settings on strain recordings and the method's ability to detect transmural radial strain gradients. In 8 anesthetized pigs (mean weight 54 kg) epicardial echocardiography was performed. Strain analysis was carried out by defining the wall as a 1-, 2-, 3-, and 4-layer structure with suitable regions of interest. Peak ejection strain was measured with SL settings of 2 to 14 mm. The systolic (ejection) strain showed large variation with SL. Sampling in one layer gave no significant reduction in strain for increasing SL. The strain in the subepicardial layer was low and decreased when the wall was divided into several layers (15.9 +/- 4.8% [2 layers]-2.1 +/- 2.4% [4 layers]; both measurements with SL = 4 mm). The method could separate 4 layers with SL of 4 mm or less, 3 layers with SL of 6 mm or less, and 2 layers with SL of 8 mm or less. When measuring radial strain in the myocardial wall the SL must be low to evaluate transmural strain gradients. With correct settings of SL and region of interest, strain in 4 layers can be distinguished. As a rule of thumb the SL should be set to approximately half the systolic thickness of the wall or half the wall layer.

In vitro evaluation of ultrasound Doppler strain rate imaging: modification for measurement in a slowly moving tissue phantom

Doppler strain rate imaging (SRI) was evaluated in vitro using a silicone strip phantom mimicking slowly moving tissue. A test apparatus was developed that enabled controlled strain experiments with variable strain and strain rate to be performed. SRI strain was measured at eight different calculated strains (range 5.7 to 63.4 %) at three different pump speeds with tissue velocity 0.1, 0.5 and 1.0 mm/s. The effect of varying tissue velocity and strain sample size on the measured SRI strain was elaborated. SRI strains agreed well with calculated values for strain when SRI strain was measured as the average over the whole strip cross-section and the strain sample size was 1.9 mm (mean difference = 2.78%, limits of agreement ± 9.97% for tissue velocity 1.0 mm/s, n = 8). The variance was substantial if single central samples were used, especially for strain sample size of 0.8 mm (mean difference = −7.47%, limits of agreement ± 20.90 for tissue velocity 0.5 mm/s, n = 24). Increasing the strain sample size to 1.9 mm removed some of the underestimation (giving mean difference of −4.46%, n = 24). We found low intra- and interobserver variation. This study indicates that, for the SRI method to give accurate estimates of strain, strain sample size should be in the region of 2 mm. Averaging over several ultrasound (US) beams increased the accuracy further.(E-mail: Knut.Matre@med.uib.no)