This study was performed to test the feasibility of using a biodegradable delivery system for the local controlled release of sodium fluoride as a mechanism for the stimulation of local bone growth. Sodium fluoride grains were mixed with poly-DL-lactic acid (PLA), and the mixture was then dissolved in acetone. After driving off the solvent, sheets of this material were rolled into rods 3.2 mm in diameter and 28.6 mm long. These were inserted into the intramedullary canals of the right femora of adult New Zealand White rabbits. A sham implant, made the same way but containing no fluoride, was inserted into the contralateral left leg. The effects of three different concentrations of sodium fluoride, 0.125 g NaF/g PLA, 0.250 g NaF/g PLA, and 0.500 g NaF/g PLA, were determined after a 4-week implantation period. In a second set of experiments, the concentration was fixed at 0.500 g NaF/g PLA with implantation durations of 4, 8, and 16 weeks. Expressed in terms of property ratios (experimental/control), bending strengths of the femora were significantly raised in most groups with the notable exception of Group 3 (0.500 g NaF/g PLA, 4 weeks). Cross-sectional area ratios in the distal femora were increased in all groups compared to right/left values for a normal unoperated group (p less than 0.05), with the highest ratio being 1.50 (SD = 0.44) for Group 4 (0.500 g NaF/g PLA, 8 weeks). Only Group 4 animals showed significant (p less than 0.05) increases in midshaft area ratio and none had responses proximally. Growth rates, measured by sequential fluorochrome labeling of bone followed the area ratio data and were only significant for the distal femora.