In heat transfer analysis of AFP process using a hot gas torch, the convective heat transfer which occurs between the hot gas flow generated by a torch nozzle and a composite substrate plays an important role in the heat transfer mechanism. In order to model the convective heat transfer, a local heat flux equation is utilized where is the energy flow per unit of area per unit of time, h is the convective heat transfer coefficient between the hot gas torch and the composite surface, and accounts for the temperature difference between the two media. This coefficient h is dependent on various number of parameters such as nozzle geometry and its configuration relative to the surface of the substrate, type and configuration of the roller, gas flow rate, temperature of the gas, type of the gas etc. Researchers on the heat transfer analysis for automated composites manufacturing have used values of h that vary from 80 W/m2K to 2500 W/m2K. This large range gives rise to uncertainties in the determination of important behavior such as the temperature distributions, residual stresses, and deformations of the composite structures due to the manufacturing process. The reason for these large differences can be due to the differences in the process parameters in each of the studies. The process parameters can include the volume flow rate of the hot gas, the gas temperature, the distance between the nozzle exit and the surface of the composite plate, the angle of the torch with respect to the surface of the substrate etc. In addition, the value of the h coefficient may not be constant over the heating length of the process. The purpose of this paper is three fold: 1. To investigate the AFP process parameters that may affect h. 2. To investigate different methods for the determination of h, and 3. To develop a procedure for less-time-consuming determination of h for the purpose of analysis for residual stresses and deformations.