Demodulation Reference Signal Research Articles

Performance of LTE ADVANCED Uplink in a Flat Rayleigh Channel

This paper describes the performance of LTE advanced uplink transmission in a flat Rayleigh channel. The uplink is simulated using a modified version of the Vienna uplink link level matlab code simulator. This modified version supports two transmission antennas instead of one. Moreover, it includes two extra processes; layer mapping and precoding. In addition, the demodulation reference signal is presented and employed to allow channel estimation. In this paper, the structure of the LTE advanced system is described. Furthermore, we present generation of the demodulation reference signal. Four combinations of two distinct channel estimation and two signal detection methods are used to provide the simulation results of performance evaluation in term of the BER and throughput curves for selected scenarios.

Joint Antenna Selection and Frequency-Domain Scheduling in OFDMA Systems with Imperfect Estimates from Dual Pilot Training Scheme

Transmit antenna selection (AS) has been adopted in contemporary wideband wireless standards such as Long Term Evolution (LTE). We analyze a comprehensive new model for AS that captures several key features about its operation in wideband orthogonal frequency division multiple access (OFDMA) systems. These include the use of channel-aware frequency-domain scheduling (FDS) in conjunction with AS, the hardware constraint that a user must transmit using the same antenna over all its assigned subcarriers, and the scheduling constraint that the subcarriers assigned to a user must be contiguous. The model also captures the novel dual pilot training scheme that is used in LTE, in which a coarse system bandwidth-wide sounding reference signal is used to acquire relatively noisy channel state information (CSI) for AS and FDS, and a dense narrow-band demodulation reference signal is used to acquire accurate CSI for data demodulation. We analyze the symbol error probability when AS is done in conjunction with the channel-unaware, but fair, round-robin scheduling and with channel-aware greedy FDS. Our results quantify how effective joint AS-FDS is in dispersive environments, the interactions between the above features, and the ability of the user to lower SRS power with minimal performance degradation.

Evolution of reference signals for LTE-advanced systems

3GPP LTE Release 10 standards (also known as LTE-Advanced) adopted some of the state-of-the-art radio access technologies that include carrier aggregation, eight-layer downlink spatial multiplexing, and four-layer uplink spatial multiplexing. For facilitating these enhancements, reference signals have significantly evolved in LTE-Advanced. This article examines underlying design principles of the LTE-Advanced reference signals. Specifically, newly introduced dedicated demodulation reference signals and channel state information reference signals for downlink and improvements of demodulation reference signals and sounding reference signals in uplink are discussed.

Demodulation Reference Signal Using Two-Dimensional Orthogonal Cover Code Mapping for Multi-Antenna/Point Transmission in LTE-Advanced Downlink

In the Long-Term Evolution (LTE)-Advanced downlink, a user-specific demodulation reference signal (DM-RS) is used to support channel estimation and data demodulation for user-transparent multi-antenna and/or multi-point (MA/P) transmission techniques. A hybrid code division multiplexing (CDM) and frequency division multiplexing (FDM) scheme is adopted as a DM-RS multiplexing scheme for up to eight data streams per user. A time-domain orthogonal cover code (OCC) is used for CDM since time domain orthogonality among OCCs offers good robustness against channel variation. However, in a medium-to-high mobility environment, orthogonality distortion occurs among OCCs, which results in performance degradation. In this paper, we propose a two-dimensional (2D)-OCC mapping that achieves two-dimensional orthogonality in the time and frequency domains to improve the performance of CDM-based DM-RSs while reducing the peak transmission power of the OFDM symbol which includes the DM-RSs. Simulation results show that the proposed 2D-OCC mapping is effective in improving the block error rate performance especially in medium-to-high mobility environments. Furthermore, it is shown that the 2D-OCC mapping effectively reduces the peak power compared to the time-domain OCC mapping.

Consistent non‐cartesian off‐axis MRI quality: Calibrating and removing multiple sources of demodulation phase errors

The consistency of off-axis MRI with non-Cartesian sequences across a large number of scanners is highly variable. Improper timing alignment of the gradient fields, data acquisition system, and real-time frequency demodulation reference signal, which are necessary for off-axis imaging, is an important source of this variability. In addition, eddy currents and anisotropic gradient delays cause deviations in k-space trajectories that in turn make the demodulation reference signals inaccurate. A method is presented to quickly measure the timing error in the frequency demodulation reference signal and separate it from anisotropic gradient delays. k-Space deviations, as measured with a previous gradient calibration technique, are shown to be a second source of demodulation phase errors that degrade image quality. Using the timing delay and k-space deviations, a retrospective phase correction is applied to each k-space sample before the data are regridded during reconstruction. The timing delays of four MR scanners were measured to be 4.2-7.5 micros below the manufacturer's suggested delay. Significant degradation in 3D radial (3D projection reconstruction (PR)) knee and breast images are retrospectively corrected while a partial prospective correction is applied for spiral imaging. The method allows for more consistent performance of non-Cartesian sequences across multiple scanners without operator intervention.

On the bit-error probability of differentially encoded QPSK and offset QPSK in the presence of carrier synchronization

We investigate the differences between allowable differential encoding strategies and their associated bit-error probability performances for quadrature phase-shift keying (QPSK) and offset QPSK modulations when the carrier demodulation reference signals are supplied by the optimum (motivated by maximum a posteriori estimation of carrier phase) carrier-tracking loop suitable for that modulation. In particular, we show that in the presence of carrier-synchronization phase ambiguity but an otherwise ideal loop, both the symbol and bit-error probabilities in the presence of differential encoding are identical for the two modulations. On the other hand, when in addition the phase error introduced by the loop's finite signal-to-noise ratio is taken into account, it is shown that the two differentially encoded modulations behave differently, and their performances are no longer equivalent. A similar statement has previously been demonstrated for the same modulations when the phase ambiguity was assumed to have been perfectly resolved by means other than differential encoding.