Crown Ether-based Chiral Stationary Phases Research Articles

Chiral recognition mechanism studies of Tyr-Arg-Phe-Lys-NH2 tetrapeptide on crown ether-based chiral stationary phase.

Even though chiral recognition for crown-ether CSPs is generally understood, on a molecular level, exact mechanisms for the resolution are still unclear. Furthermore, short peptide analytes often contain multiple amino moieties capable of binding to the crown ether selector. In order to extend the understanding in chiral recognition mechanisms, polar organic mode separation of Tyr-Arg-Phe-Lys-NH2 tetrapeptide llll/dddd enantiomers on S- and R-(3,3'-diphenyl-1,1'-binaphthyl)-20-crown-6 stationary phases was studied with 50-mM perchloric acid in methanol as mobile phase. Deviation from the generally acceptable 1:1 stoichiometry was supported by mass spectroscopy analysis of the formed complexes between tetrapeptide enantiomer and crown ether selectors, which revealed adducts possessing 1:1, 1:2, and 1:3 stoichiometry. Further investigation of complexation induced shifts by NMR indicated on different binding mechanisms between llll/dddd enantiomers of Tyr-Arg-Phe-Lys-NH2 and crown ether selectors. Enantioselective proton shifts were observed in studied tetrapeptide tyrosine and phenylalanine residues exclusively for llll enantiomer upon binding with S-(3,3'-diphenyl-1,1'-binaphthyl)-20-crown-6 selector (and dddd enantiomer with R-(3,3'-diphenyl-1,1'-binaphthyl)-20-crown-6 selector), indicating that these two amino acid residues contribute to chiral recognition. The obtained results were in agreement with the LC data.

Chiral LC-MS/MS method for the discrimination of triiodothyronine enantiomers on a crown ether-based chiral stationary phase.

Considering the greater pharmaceutical and clinical interest of triiodothyronine (T3 ) thyroid hormone, an effective D/L-T3 enantiomer separation was performed on a crown ether-based chiral stationary phase by LC-MS/MS. In optimal analytical condition and selected reaction monitoring mode, the two enantiomers of T3 were baseline separated within 10min. The limit of detection and limit of quantitation were found to be 0.05 and 0.10ng/μl; 0.20 and 0.50 ng/μl for D- and L-T3 , respectively. During validation, this method proved to be feasible, accurate as well as enantioselective and sensitive for the resolution of T3 enantiomers. For commercial D- and L-T3 chemicals, the enantiomeric impurities as the other enantiomer were 0.11% and 4.61%. On the other hand, the impurity as D-T3 for commercial pharmaceutical products (liothyronine sodium tablets, two suppliers) was 0.68% and 6.57%.

Enantioseparation of DPP-4 Inhibitors on Immobilized Crown Ether-Based Chiral Stationary Phase

A group of DPP-4 inhibitors such as alogliptin, linagliptin and saxagliptin were selected for enantioseparation for this study. Crown ether columns contain a chiral crown ether ring as a chiral selector is suitable for the compounds having primary amino groups. Since the selected compounds contain free amino groups, a crown ether column was selected for enantiomeric separation of dipeptidyl peptidase-4 inhibitors. Dipeptidyl peptidase-4 inhibitors are a class of oral hypoglycemics that block dipeptidyl peptidase-4 enzyme and can be used to treat diabetes mellitus type 2. A sensitive HPLC method was developed to separate the enantiomers of each dipeptidyl peptidase-4 inhibitor. Effects of various parameters such as type of solvents, selection of additives, effect of pH and column temperature on chromatographic results were studied. The optimal conditions for the chiral separation of dipeptidyl peptidase-4 inhibitors without any derivatization were investigated.

Development of HPLC Chiral Stationary Phases Based on (+)-(18-Crown-6)-2,3,11,12-tetracarboxylic Acid and Their Applications.

Crown ether-based chiral stationary phases (CSPs) have been known to be useful for the resolution of racemic primary amino compounds. In particular, CSPs based on (+)-(18-crown-6)-2,3,11,12-tetracarboxylic acid have been reported to be useful for the resolution of secondary amino compounds as well as primary amino compounds. In this article, the process of developing various CSPs based on (+)-(18-crown-6)-2,3,11,12-tetracarboxylic acid to improve the chiral recognition efficiency and/or the stability of the CSPs and their applications to the resolution of various primary and nonprimary amino compounds are reviewed.

Liquid chromatographic resolution of amino acid esters of acyclovir including racemic valacyclovir on crown ether-based chiral stationary phases.

Valacyclovir, a potential prodrug for the treatment of patients with herpes simplex and herpes zoster, and its analogs were resolved on two chiral stationary phases (CSPs) based on (3,3'-diphenyl-1,1'-binaphthyl)-20-crown-6 covalently bonded to silica gel. In order to find out an appropriate mobile phase condition, various mobile phases consisting of various organic modifiers in water containing various acidic modifiers were applied to the resolution of valacyclovir and its analogs. When 30% acetonitrile in water containing any of 0.05 M, 0.10 M, or 0.15 M perchloric acid was used as a mobile phase, valacyclovir and its analogs were resolved quite well on the two CSPs with the separation factors (α) in the range of 2.49 ~ 6.35 and resolutions (RS ) in the range of 2.95 ~ 12.21. Between the two CSPs, the CSP containing residual silanol protecting n-octyl groups on the silica surface was found to be better than the CSP containing residual silanol groups.

Liquid Chromatographic Resolution of Mexiletine and Its Analogs on Crown Ether‐Based Chiral Stationary Phases

Mexiletine, an effective class IB antiarrhythmic agent, and its analogs were resolved on three different crown ether-based chiral stationary phases (CSPs), one (CSP 1) of which is based on (+)-(18-crown-6)-2,3,11,12-tetracarboxylic acid and the other two (CSP 2 and CSP 3) are based on (3,3'-diphenyl-1,1'-binaphthyl)-20-crown-6. Mexiletine was resolved with a resolution (R(S)) of greater than 1.00 on CSP 1 and CSP 3 containing residual silanol group-protecting n-octyl groups on the silica surface, but with a resolution (R(S)) of less than 1.00 on CSP 2. The chromatographic behaviors for the resolution of mexiletine analogs containing a substituted phenyl group at the chiral center on the three CSPs were quite dependent on the phenoxy group of analytes. Namely, mexiletine analogs containing 2,6-dimethylphenoxy, 3,4-dimethylphenoxy, 3-methylphenoxy, 4-methylphenoxy, and a simple phenoxy group were resolved very well on the three CSPs even though the chiral recognition efficiencies vary with the CSPs. However, mexiletine analogs containing 2-methylphenoxy group were not resolved at all or only slightly resolved. Among the three CSPs, CSP 3 was found to show the highest chiral recognition efficiencies for the resolution of mexiletine and its analogs, especially in terms of resolution (R(S)).

A simple chromatographic route for the isolation of meso diaminopimelic acid

Meso diaminopimelic acid is an important noncoded amino acid found in Gram-negative bacterial peptidoglycan. In spite of its importance, this stereoisomer is not available commercially. A simple, economical procedure was developed for the isolation of pure meso diaminopimelic acid via an high-performance liquid chromatography separation. In our new approach, the underivatized three isomers of diaminopimelic acid were separated on a crown ether-based chiral stationary phase. For the structure identification, (1)H NMR spectroscopy was applied.

Preparation of a new crown ether-based chiral stationary phase containing thioester linkage for the liquid chromatographic separation of enantiomers

A new chiral stationary phase (CSP) containing thioester linkages was prepared by bonding (+)-(18-crown-6)-2,3,11,12-tetracarboxylic acid to mercaptopropylsilica gel. The chiral recognition ability of the new CSP was found to be greater than that of the previously reported CSP containing amide linkages in the resolution of the various α-amino acids that were tested, except for that of Met, Ser and Thr. In the resolution of racemic amines and amino alcohols, the new CSP was always better than the one containing amide linkages in terms of the separation factors ( α) and the resolutions ( R S). Given the identical elution orders on the two CSPs, it was concluded that the chiral recognition mechanism is not affected by the change of the linkage type. In addition, the new CSP was found to be quite stable under the acidic mobile phase conditions that were utilized, indicating that the thioester linkage is useful as a tethering group.

Preparation and application of a chiral stationary phase based on (+)-(18-crown-6)-2,3,11,12-tetracarboxylic acid without extra free aminopropyl groups on silica surface

A crown ether-based chiral stationary phase (CSP) without extra aminopropyl groups on the surface of silica gel was newly prepared by bonding (+)-(18-crown-6)-2,3,11,12-tetracarboxylic acid to silica gel. The new CSP was applied to the resolution of various racemic alpha-amino acids, amines, and amino alcohols. The chiral recognition efficiency of the new CSP was generally superior to that of the original CSP containing unreacted residual aminopropyl groups on the surface of silica gel in terms of the separation (alpha) and the resolution factors (Rs). The retention behaviors of analytes on the new CSP with the variation of the content of organic and acidic modifiers in aqueous mobile phase were consistent with those on the original CSP in the resolution of alpha-amino acids, but somewhat different in the resolution of racemic amines and amino alcohols from those on the original CSP and the difference was rationalized by the lipophilicity difference of the two CSPs. The effect of the column temperature on the chromatographic resolution behaviors on the new CSP was consistent with that on the original CSP.

The on-line determination of the enantiomeric purity of enzymatically produced chiral compounds

A prototype of a coupled-column chromatographic system has been developed to determine the enantiomeric purity of enzymatically produced chiral compounds. In this system, an immobilized enzyme HPLC reactor based upon α-chymotrypsin (ACHT-IMER) was linked through a switching valve to a chromatographic column containing a crown ether-based chiral stationary phase (CR-CSP). Although ACHT is normally stereospecific for the L-enantiomorphs of aromatic amino acids, L-tryptophan (L-TRP), L-tyrosine and L-phenylalanine, we were able to achieve the hydrolysis of D-TRP methyl and ethyl esters on the ACHT-IMER. The percent of hydrolysis of the D-TRP esters could be manipulated by varying the resident time in the ACHT-IMER. In a series of experiments, D,L-TRP methyl or ethyl esters were injected into the ACHT-IMER, the flow stopped and after resuming the flow, the eluent which contained the hydrolyzed aminoacids, D- and L-TRP, was switched onto the CR-CSP where the enantiomeric composition of the TRP peak was determined. This configuration is a model for other IMER/CSP coupled-column systems which can be used for analytical and preparative applications.

Improved crown ether-based chiral stationary phase

An improved crown ether-based chiral stationary phase (CSP) was prepared by dynamic coating of a reversed-phase silica gel with a new chiral crown ether which was designed to have more lipophilicity than the previously used one, while preserving the basic structure responsible for chiral recognition. The CSP showed not only excellent enantioselectivity for amino acids, but also higher stability against organic solvents in the mobile phase. No desorption of the crown ether from the support was observed in a mobile phase containing up to 40% of methanol. An increase in methanol concentration in the mobile phase gave rise to a decrease in the retention of amino acids and an increase in the “apparent” enantioselectivity, i.e., the separation coefficient and the resolution factor. A possible retention mechanism is proposed to explain these behaviours.