Source Of Correlated Photon Pairs Research Articles

Demonstration of a low loss, highly stable and re-useable edge coupler for high heralding efficiency and low g(2)(0) SOI correlated photon pair sources.

We report a stable, low loss method for coupling light from silicon-on-insulator (SOI) photonic chips into optical fibers. The technique is realized using an on-chip tapered waveguide and a cleaved small core optical fiber. The on-chip taper is monolithic and does not require a patterned cladding, thus simplifying the chip fabrication process. The optical fiber segment is composed of a centimeter-long small core fiber (UHNA7) which is spliced to SMF-28 fiber with less than -0.1 dB loss. We observe an overall coupling loss of -0.64 dB with this design. The chip edge and fiber tip can be butt coupled without damaging the on-chip taper or fiber. Friction between the surfaces maintains alignment leading to an observation of ±0.1 dB coupling fluctuation during a ten-day continuous measurement without use of any adhesive. This technique minimizes the potential for generating Raman noise in the fiber, and has good stability compared to coupling strategies based on longer UHNA fibers or fragile lensed fibers. We also applied the edge coupler on a correlated photon pair source and observed a raw coincidence count rate of 1.21 million cps and raw heralding efficiency of 21.3%. We achieved an auto correlation function g H(2)(0) as low as 0.0004 at the low pump power regime.

Non-collinear generation of ultra-broadband parametric fluorescence photon pairs using chirped quasi-phase matching slab waveguides.

Many optical quantum applications rely on broadband frequency correlated photon pair sources. We previously reported a scheme for collinear emission of high-efficiency and ultra-broadband photon pairs using chirped quasi-phase matching (QPM) periodically poled stoichiometric lithium tantalate (PPSLT) ridge waveguides. However, collinearly emitted photon pairs cannot be directly adopted for applications that are based on two-photon interference, such as quantum optical coherence tomography (QOCT). In this work, we developed a chirped QPM device with a slab waveguide structure. This device was designed to produce spatially separable (photon pair non-collinear emission) parametric fluorescence photon pairs with an ultra-broadband bandwidth in an extremely efficient manner. Using a non-chirped QPM slab waveguide, we observed a photon pair spectrum with a full-width-at-half-maximum (FWHM) bandwidth of 26 nm. When using a 3% chirped QPM slab waveguide, the FWHM bandwidth of the spectrum increased to 190 nm, and the base-to-base width is 308 nm. We also confirmed a generation efficiency of 2.4×106 pairs/(μW·s) using the non-chirped device, and a efficiency of 8×105 pairs/(μW·s) using the 3% chirped device under non-collinear emission conditions after single-mode fiber coupling. This is, to the best of our knowledge, the first report of frequency correlated photon pairs generation using slab waveguide device as a source. In addition, using slab waveguides as photon pair sources, we performed two-photon interference experiments with the non-chirped device and obtained a Hong-Ou-Mandel (HOM) dip with a FWHM of 7.7 μm and visibility of 98%. When using the 3% chirped device as photon pair source, the HOM measurement gave a 2 μm FWHM dip and 74% visibility.

Compact, single-mode fiber-coupled, correlated photon pair source based on type-I beta-barium borate crystal

A small, portable, high-flux correlated photon-pair source has been designed and constructed from simple opto-mechanical parts. Unique to this device is its straightforward alignment process, together with the direct coupling of signal and idler photons into polarization-maintaining single-mode optical fibers. Spontaneous parametric down-conversion is used to produce photon pairs in β-barium borate (BBO) at a center wavelength of 810 nm. Owing to the applied type-I phase-matching, coincident photons have identical polarization. The estimated fiber-coupling efficiency is 51%, the measured photon and coincidence flux are 636 and 130 kHz/mW, respectively, normalized to pump power (44 mW). The source has an extremely wide wavelength spectrum of 202-nm FWHM, measured at the fiber output, which limits the actual heralding ratio to 20%.

Quantum-enhanced standoff detection using correlated photon pairs

We investigate the use of correlated photon pair sources for the improved quantum-level detection of a target in the presence of a noise background. Photon pairs are generated by spontaneous four-wave mixing, one photon from each pair (the herald) is measured locally while the other (the signal) is sent to illuminate the target. Following diffuse reflection from the target, the signal photons are detected by a receiver and non-classical timing correlations between the signal and herald are measured in the presence of a configurable background noise source. Quantum correlations from the photon pair source can be used to provide an enhanced signal-to-noise ratio when compared to a classical light source of the same intensity.

Correlated Photon-Pair Source Stabilized by Feedback System With DFG Efficiency Monitoring

In this letter, we report a simple and general method of integrity monitoring and feedback of a quantum-correlated photon-pair source for the long-term stable operation. The system utilizes the general relationship between efficiency of differential-frequency generation ( $\eta $ ) and generation rate of the photon-pairs per unit frequency per unit time via spontaneous parametric down conversion ( $\mu $ ) of $\mu =K\eta ~ \text {with}~ K=1$ pair/Hz/s. The experimental results using a periodically poled LiNbO3 device verified the merits of the proposed system. The device could generate stable photon-pairs with the same $\mu $ even when the device operation temperature was remarkably changed, and the operation condition was deviated from the optimum (phase matched) condition.

Generation of entangled photons using an arrayed waveguide grating

We propose an on-chip source of entangled photon pairs that uses an arrayed-waveguide grating (AWG) with multiple nonlinear input waveguides as correlated photon pair sources. The AWG wavelength-demultiplexes photon pairs created in input waveguides and simultaneously produces a high-dimensional entangled state encoded in the optical path. We implemented the device with a monolithic silicon–silica waveguide integration platform and demonstrated the entanglement of two dimensions in a proof-of-principle experiment.

Sub-Shot-Noise Transmission Measurement Enabled by Active Feed-Forward of Heralded Single Photons

Harnessing the unique properties of quantum mechanics offers the possibility to deliver new technologies that can fundamentally outperform their classical counterparts. These technologies only deliver advantages when components operate with performance beyond specific thresholds. For optical quantum metrology, the biggest challenge that impacts on performance thresholds is optical loss. Here we demonstrate how including an optical delay and an optical switch in a feed-forward configuration with a stable and efficient correlated photon pair source reduces the detector efficiency required to enable quantum enhanced sensing down to the detection level of single photons. When the switch is active, we observe a factor of improvement in precision of 1.27 for transmission measurement on a per input photon basis, compared to the performance of a laser emitting an ideal coherent state and measured with the same detection efficiency as our setup. When the switch is inoperative, we observe no quantum advantage.

Quantifying the momentum correlation between two light beams by detecting one

We report a measurement of the transverse momentum correlation between two photons by detecting only one of them. Our method uses two identical sources in an arrangement in which the phenomenon of induced coherence without induced emission is observed. In this way, we produce an interference pattern in the superposition of one beam from each source. We quantify the transverse momentum correlation by analyzing the visibility of this pattern. Our approach might be useful for the characterization of correlated photon pair sources and may lead to an experimental measure of continuous variable entanglement, which relies on the detection of only one of two entangled particles.

Circumventing spontaneous Raman noise in a correlated photon pair source

We propose a dual-pump third-order nonlinear scheme for producing pairs of correlated photons that is less susceptible to Raman noise than typical spontaneous four-wave mixing (SFWM) methods. Beginning with the full multimode Hamiltonian, we derive a general expression for the joint spectral amplitude, from which the probability of producing a pair of photons can be calculated. As an example, we demonstrate that a probability of 0.012 pairs per pulse can be achieved in an appropriately designed fused silica microfiber. As compared with single pump SFWM in standard fiber, we calculate that our process shows significant suppression of the spontaneous Raman scattering and an improvement in the signal to noise ratio.

Spontaneous four-wave mixing in liquid-core fibers: towards fibered Raman-free correlated photon sources

We experimentally demonstrate, for the first time to our knowledge, the generation of correlated photon pairs in a liquid-core photonic crystal fiber. Moreover, we show that, thanks to the specific Raman properties of liquids, the Raman noise (which is the main limitation of the performance of silica-core fiber-based correlated photon pair sources) is highly reduced. With a demonstrated coincident-to-accidental ratio equal to 63 and a pair generation efficiency of about 10−4 per pump pulse, this work contributes to the development of high-quality correlated photon pair sources for quantum communications.

基于不同种类光纤的量子关联光子对源输出特性比较

基于不同种类光纤的量子关联光子对源输出特性比较

Continuous-wave quasi-phase-matched waveguide correlated photon pair source on a III–V chip

We report on the demonstration of correlated photon pair generation in a quasi-phase-matched superlattice GaAs/AlGaAs waveguide using a continuous-wave pump. Our photon pair source has a low noise level and achieves a high coincidence-to-accidental ratio greater than 100, which is the highest value reported in III–V chips so far. This correlated photon pair source has the potential to be monolithically integrated with on-chip pump laser sources fabricated on the same superlattice wafer structure, enabling direct correlated/entangled photon pair production from a compact electrically powered chip.

Integrated spatial multiplexing of heralded single-photon sources.

The non-deterministic nature of photon sources is a key limitation for single-photon quantum processors. Spatial multiplexing overcomes this by enhancing the heralded single-photon yield without enhancing the output noise. Here the intrinsic statistical limit of an individual source is surpassed by spatially multiplexing two monolithic silicon-based correlated photon pair sources in the telecommunications band, demonstrating a 62.4% increase in the heralded single-photon output without an increase in unwanted multipair generation. We further demonstrate the scalability of this scheme by multiplexing photons generated in two waveguides pumped via an integrated coupler with a 63.1% increase in the heralded photon rate. This demonstration paves the way for a scalable architecture for multiplexing many photon sources in a compact integrated platform and achieving efficient two-photon interference, required at the core of optical quantum computing and quantum communication protocols.

Correlated Photon-Pair Source for Secured $C$-Band Quantum Communications

We have experimentally investigated and shown evidence of correlated photon-pair generation based on coupled intracavity four-wave mixing (FWM) in a dual-wavelength erbium-doped fiber ring laser operating in the fiber-optic communication <i xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">C</i> -band regime. In the coupled FWM process, the pump photons are both involved in the absorption and stimulated emission, which generate signal and idler wavelengths simultaneously. The correlation experiment was performed with various photon count levels in the order of hundreds of photons/s at each channel. The photon number of channel was less than 0.1/pulse and the maximum coincidence to single counts ratio was approximately 12% with a Gaussian profile in the accumulated counts.

Correlated Photon Pair Generation in Silicon Wire Waveguides at 1.5 μm

Correlated photon pairs at 1.5μm are generated in a silicon wire waveguide (SWW) with a length of only 1.6mm. Experimental results show that the single-side count rates on both sides increase quadratically with pump light, indicating that photons are generated from the spontaneous four-wave mixing (SFWM) processes. The quantum correlation property of the generated photons is demonstrated by the ratio between coincident and accidental coincident count rates. The highest ratio measured at room temperature is to be about 19, showing that generated photon pairs have strong quantum correlation property and low noise. What is more, the wavelength correlation property of the coincident count is also measured to demonstrate the correlated photon pair generation. The experimental results demonstrate that SWWs have great potential in on-chip integrated low-noise correlated photon pair sources at 1.5 μm.

Noncollinear correlated photon pair source in the 1550 nm telecommunication band

We present a source of noncollinear correlated photon pairs in the standard 1550 nm telecommunication band. They are generated by a spontaneous parametric down-conversion process and emitted in a cone because of type-I noncollinear phase matching. Within the band, the source gives a completely flexible choice of the frequencies of the photon pairs, and correlation properties related to spatial momentum as well as energy and time can easily be utilized.We characterize the source by measuring the spatial intensity distribution of the down-converted light and by performing coincidence counting.