Continuous Positive Airway Pressure Mode Research Articles

Restoration of volume by crystalloid versus colloid after coronary artery bypass

We compared Ringer's acetate-gluconate solution with 6% dextran-70 infused during rewarming after coronary bypass surgery. In a randomized study, 18 patients received 56 +/- 15 ml/kg of crystalloid (group 1), and 14 patients received 16 +/- 6 ml/kg of dextran (group 2). Data were taken at the following intervals: 4 to 5 h after terminating the cardiopulmonary bypass, after rewarming, the next morning on controlled ventilation and continuous positive airway pressure (CPAP) breathing, and after extubation. The patients were followed for 14 days. Prophylactic nitroglycerin infusion may have increased the need for plasma expansion. After volume loading, the stroke index increased in both groups, but the left ventricular stroke work index increased in group 2 only. After transition to the CPAP mode, hydrostatic pressures increased, more in group 2, doubling the pulmonary shunt flow. Pulmonary extravascular thermal volume did not change in either group. We conclude that hemodynamic stability occurred faster with dextran, and ventilatory weaning was somewhat easier with crystalloid.

Pressure characteristics of the Ambu CPAP system and the Servo Ventilator 900C in CPAP mode

Spontaneous breathing was stimulated in the Ambu continuous positive airway pressure (CPAP) system and the Servo Ventilator 900C by means of a lung model programmed to mimic the respiratory flow patterns of a healthy volunteer and a patient in severe respiratory distress. Changes in airway pressure, flow and volume were recorded during "breathing" with CPAP at 0.5, 1.0 and 1.5 kPa. In the Ambu system, the airway pressure decreased during inspiration and increased during expiration, while the mean airway pressure was close to the pre-set CPAP value. The pressure changes were minimal when the fresh gas flow was increased from 15 to 25 1 X min-1. The higher fresh gas flow is recommendable during deep or rapid breathing. In the Servo ventilator 900C, there was a short initial inspiratory pressure drop, succeeded by a pressure rise above the CPAP value. The expiratory airway pressure was somewhat higher than CPAP. Both systems were found to be recommendable for clinical use.

A system to measure functional residual capacity in critically ill patients.

The use of continuous positive airway pressure (CPAP) and intermittent mandatory ventilation (IMV) in spontaneously breathing, intubated patients has prompted the development of new procedures for measuring functional residual capacity (FRC). The authors have developed a system for measuring FRC by the multiple breath nitrogen washout technique, which is suitable for use on intubated patients breathing with CPAP, IMV, or intermittent positive pressure ventilation (CONTROL) and on nonintubated patients. This system uses a pair of synchronized volume ventilators to permit a step change in inspired N2 fraction while providing therapeutic ventilatory support. A rapid-response nitrogen analyzer and a modified bellows spirometer are used for continuous measurement of airway nitrogen concentration and expired gas flow rate. FRC is calculated on-line by a digital computer. The system accuracy was tested on a mechanical lung simulator in the CPAP and CONTROL modes. The measured volume was found to agree within 58 +/- 52 ml of the actual volume in the CONTROL mode and within 104 +/- 22 ml in the CPAP mode. The system was also tested for repeatability by making duplicate FRC determinations in patients with respiratory insufficiency. In the 18 patients studied, the correlation coefficient of these duplicate measurements was r = 0.987 and the mean difference between measurements was 49 +/- 24 ml. This noninvasive system also provides data used to calculate anatomical deadspace by Fowler's method (VSDS) and uniformity of ventilation (V/V) for multicompartment lung models.