Conductive Cladding Layers Research Articles

Polymeric waveguide electro-optic beam-steering device with DNA biopolymer conductive cladding layers

A polymer electro-optic (EO) waveguide beam-steering device with deoxyribonucleic acid (DNA) biopolymer conductive cladding layers and a core layer of the commercially available EO polymer SEO100 is demonstrated with 100% relative poling efficiency. This demonstration device exhibits a deflection efficiency of 99 mrad/kV with a corresponding in-device EO coefficient r33 of 124 pm/V at 1550 nm. When the DNA biopolymer bottom cladding layer is replaced by the commonly used cladding polymer UV15, the deflection efficiency and in-device r33 drop to 34 mrad/kV and 43 pm/V, respectively.

DNA biopolymer conductive cladding for polymer electro-optic waveguide modulators

A deoxyribonucleic acid (DNA) biopolymer has been studied for use as a conductive cladding layer in polymer electro-optic (EO) waveguide modulators due to its low optical loss and high electrical conductivity relative to its inorganic polymer counterparts. Electric field contact poling measurements using a DNA biopolymer cladding layer with an amorphous polycarbonate/chromophore (APC/CLD1) guest-host system core layer have been made and compared to a UV15 cladding layer. Using the EO coefficient of APC/CLD1 with no cladding layer as a baseline, the DNA biopolymer cladding layer yielded relative poling efficiencies of 96% while the UV15 poling efficiencies were only 51%.

Investigation of Polymers and Marine-Derived DNA in Optoelectronics

Our research in nonlinear optic (NLO) polymer-based electro-optic (EO) modulators has centered on optimizing device performance through the using of polymer cladding layers with higher relative conductivities than the NLO core material. We have demonstrated as much as a 10 times increase in the effective EO coefficient of electrode poled, guest/host NLO polymers, compared to using passive polymer claddings. We have achieved the lowest poling voltage to date for maximum EO coefficient, 300 V, for a two-layer waveguide structure consisting of a 2 μm thick NLO polymer layer and 2 μm thick conductive cladding layer. Optimized polymer cladding materials posessing the desired optical and electromagnetic properties we find need to be balanced with materials processability. In addition to the conventional polymer materials under investigation, a novel material, deoxyribonucleic acid (DNA), derived from salmon sperm, has shown promise in providing both the desired optical and electromagnetic properties, as well as...

Effect of conductivity and dielectric constant on the modulation voltage for optoelectronic devices based on nonlinear optical polymers

Presented is the effect of using various cladding materials with different conductivities and dielectric constants on the applied voltage for optoelectronic (OE) devices based on nonlinear optical (NLO) polymers. Using a conductive polymer, we have demonstrated a 3 to 13 times increase in the effective electro-optic (EO) coefficient of electrode- poled NLO polymers, compared to using passive polymer claddings. We have achieved the lowest poling voltage to date for maximum EO coefficient, 300 V, for a two-layer waveguide structure consisting of a 2-?m- thick NLO polymer layer and a 2-?m-thick conductive cladding layer. The dielectric constants of both the NLO polymer core and passive polymer cladding materials used for conventional polymer-based integrated optic devices are typically very similar in magnitude. This suggests that only a small fraction of the applied modulation voltage is reaching the NLO polymer core layer, requiring 4 to 5 times higher modulation voltage than the desired V?. We have demonstrated a factor-of-2 decrease in the modulation voltage using the same conductive polymer, due to its possessing a much higher dielectric constant than the core material at the modulation frequency tested. The results show promise for shorter, lower-operating-voltage devices.