Methods to optimize the diffusion bonding (DB) process while also creating lap joints were investigated using AZ31, the commercial Mg alloy, focusing primarily on studying the effects of varying conventional process parameters and more importantly, exploring the influence of surface roughness on creating an acceptable strong bond. The results indicate that when contact is made between surface areas of roughness (Ra > 0.2 ㎛) diffusion is facilitated at reduced process parameters of time and temperature. Furthermore, this early bond initiation combined with the optimized DB process parameters results in a stronger bond with strengths increasing by ~ 150% in comparison to the DB samples created with a smooth surface finish. Additionally, less than 20% total overall distortion is observed while preserving a uniform microstructure of consistent grain sizes in the material over the entire joining region compared with the parent material.