Changes In Flexion Angle Research Articles

Prediction of Postoperative Range of Motion after Mobile-Bearing Medial Unicompartmental Knee Arthroplasty from the Preoperative Range of Motion and Other Preoperative Factors.

Postoperative flexion after unicompartmental knee arthroplasty might be predicted from the preoperative range of motion and other preoperative factors, but this has not been sufficiently investigated. Between 2013 and 2017, 198 patients (198 knees) underwent unilateral knee arthroplasty with medial mobile-bearing unicompartmental knee arthroplasty. Range of motion was measured preoperatively and at the time of final follow-up. To investigate the accuracy of the prediction of preoperative to postoperative gain or loss of the flexion angle, we performed receiver operating characteristic analysis. Logistic regression analysis was used to evaluate other predictive factors. Change in flexion angle was significantly strongly and negatively correlated with the preoperative flexion angle (R = - 0.688; 95% confidence interval: -0.755 to -0.607; p < 0.001). Preoperative flexion angle was suggested to be a significant predictor of gain or loss of the flexion angle with the area under the curve of 0.781; the cutoff value calculated using the Youden index was 140 degrees. Logistic regression analysis showed that in addition to the preoperative flexion angle of the operated side, the postoperative flexion range was significantly affected by the patient's height and by the preoperative flexion angle of the contralateral knee. If the preoperative flexion angle in Oxford mobile-bearing medial unicompartmental knee arthroplasty is <140 degrees, the postoperative flexion angle may be improved; if it exceeds 140 degrees, the postoperative flexion angle may worsen. This predictive ability is further improved by consideration of the patient's height and the range of motion on the contralateral side.

The posterior tibial slope does not influence the flexion angle in posterior-stabilized mobile-bearing total knee arthroplasty

BackgroundIt remains uncertain whether an increase in the tibial slope leads to better flexion in posterior-stabilized (PS) total knee prostheses.PurposeTo compare the intra-operative flexion angle between standard and an additional 10° posterior slope inserts.Patients and methodsBetween December 2014 and February 2015, 22 patients (25 knees) who underwent PS mobile-bearing primary total knee arthroplasty (TKA) were included. Flexion angles were measured using either standard or specially-made inserts. Differences in flexion angles between the two situations were analyzed to determine the relationship between changes in flexion angle and pre-operative flexion angle or body mass index (BMI), and between intra- and post-operative flexion angle.ResultsThe difference between the average flexion angle of standard inserts and specially-made inserts was not statistically significant. Although the correlations between changes in flexion angle due to insert difference and flexion angle, pre-operative flexion angle or BMI were not significant, there was a positive correlation between intra-operative and post-operative flexion at 2 years.ConclusionThe results showed an additional posterior tibial slope by 10° did not affect the intra-operative flexion angle. Surgeons performing PS mobile-bearing TKA do not need to excessively slope the tibial bone cutting to improve the post-operative flexion angle.Level of evidenceI, Experimental study.

Is postoperative flexion angle genuinely better in unicompartmental knee arthroplasty than in total knee arthroplasty? A comparison between the knees in the same patients

BackgroundThe aim of this retrospective study was to clarify if unicompartmental knee arthroplasty (UKA) can acquire a greater postoperative flexion angle than total knee arthroplasty (TKA) in the same individuals after adjusting for the preoperative flexion angle and if the preoperative flexion angle correlates with the change in flexion postoperatively. MethodsThirty-five patients between 2011 and 2017 who had undergone simultaneous TKA on one knee and UKA on the other knee were included in the study. Range of motion was measured preoperatively and at one year after the surgery. The relationship between the pre- and postoperative flexion angles was evaluated. ResultsUKA can acquire approximately 10° greater flexion postoperatively when compared to TKA, even after adjustment for the preoperative flexion angle. The preoperative flexion angle is strongly and negatively correlated with the change in flexion angle in both the TKA and UKA knees. A preoperative knee with a smaller flexion angle will gain greater flexion postoperatively, whereas a preoperative knee with a greater flexion angle tends to lose flexion angle. The thresholds of gain/loss are estimated as 123° and 135° in TKA and UKA knees, respectively. ConclusionsThese results provide an evidence that the UKA can acquire a greater postoperative flexion angle than the TKA and valuable information for patients who demand a deep postoperative flexion angle.

High Axial Loads While Walking Increase Anterior Tibial Translation in Intact and Anterior Cruciate Ligament–Deficient Knees

To evaluate the effect of high axial loading (AL) on anterior tibial translation (ATT) according to the increase in knee flexion and the effect of valgus stress (VS) and internal rotation (IR) combined with high AL in intact and anterior cruciate ligament (ACL)-deficient knees according to the increase in knee flexion. We used 10 fresh-frozen, human cadaveric knees. Different loading conditions (134-N anterior drawer, 1,000-N AL, 10-Nm VS, and 5-Nm IR) were sequentially combined, and ATT was measured at 0°, 15°, 30°, 45°, and 60° of flexion in the intact and ACL-deficient knees. ATT increased significantly by adding high AL in intact knees (P= .001) and ACL-deficient knees (P< .0001) according to the change in flexion angle (P < .0001). Under high AL, ATT in the ACL-deficient knees was significantly larger than that in the intact knees for all loading conditions, and it also increased gradually according to the increase in knee flexion (P= .0001). ATT increased significantly after adding IR or VS with high AL in intact knees (VS, P= .002; VS/IR, P= .03) and ACL-deficient knees (VS, P= .0004) at some of the flexion angles. The added high AL increased ATT in intact and ACL-deficient knees from 0° to 60° of flexion. The effect of high AL on ATT became greater in ACL-deficient knees than in intact knees, and ATT also gradually increased according to the increase in knee flexion from 0° to 60°. In both the intact and ACL-deficient knees, ATT increased significantly after valgus stress or IR from 0° to 60°. ATT during weight bearing increases stress to the ACL, which worsens with valgus stress and/or IR forces. This finding should be considered when one is studying ACL injury mechanisms, as well as prescribing rehabilitation after ACL surgery.

A Simple Goniometer for Use Intraoperatively in Total Knee Arthroplasty

Intraoperative range of motion (ROM) assessment can be challenging during total knee arthroplasty (TKA) surgery. As computer assisted surgery is costly and not readily available to many surgeons, we have developed a simple, cost-effective intraoperative device to precisely measure knee flexion and extension. A simple knee goniometer system was constructed consisting of a digital level mounted to a base that rigidly attaches two standard needles. The needles are pushed through the overlying soft tissue of the distal femur. The device is then applied to the proximal tibia, where an angle measurement of the knee is registered. A validation study for this device was conducted on two pairs of intact cadaveric lower limbs at 0 deg, 10 deg, 15 deg, 20 deg, 25 deg, and 30 deg. Two orthopedic surgeons experienced with the system performed three measurements at each angle. Systematic error, defined as the goniometer reading at 0 deg flexion anatomically as determined by the navigation system, ranged from −9.1 deg to 3.0 deg, consistent for each operator on every case. Measurement error, defined as the variability in repeated, fixed angle measurements made with the goniometer, was 1.5 ± 1.0 deg across all surgeons, cases, and prescribed flexion angles. For both surgeons and all imposed flexion angles, measurement errors were below the 4 deg clinical threshold. The simple knee goniometer system generated accurate, repeatable measures of changes in flexion angle intraoperatively with measurement error comparable to errors obtained using the commercial navigation system (1 deg–2 deg). However, the knee goniometer is less complex, less time intensive, and less costly than currently available computer assistive devices. Taken together, our results are very promising for the continued development of this device.

Effect of Total Knee Arthroplasty Implant Position on Flexion Angle Before Implant-Bone Impingement

We generated patient-specific computer models of total knee arthroplasty from 10 patients to compute maximum flexion angle before implant-bone impingement. Motion was simulated for 5 different femoral implant positions and 11 different tibial insert positions at 4 different tibial posterior slopes. In the neutral position, the mean maximum flexion angle was 136.3°. The range because of anatomical variation among patients was 13.0°. A combination of 2-mm posterior translation of the femoral component with a 10-mm anterior translation of the insert and a 7° posterior slope increased flexion by a mean of 14° relative to the neutral position. The rate of change in flexion angle was 0.4°/mm to 1.5°/mm with respect to implant position and 1.5°/mm increase in the posterior condylar offset.

Change of cervical balance following single to multi-level interbody fusion with cage

Postoperative limitation of cervical movement and adjacent disc degeneration are major causes of postoperative neck pain after anterior cervical discectomy and interbody fusion (ACDF). We present a retrospective study of dynamic radiographic change following ACDF with cages. We performed ACDF in 50 patients with cervical degenerative diseases, divided into three groups based on the level of interbody fusion (Group A: one-level; Group B: two-level; Group C: three-level). Preoperative and postoperative flexion-extension X-rays were acquired and cervical range of motion (ROM), lordosis, fusion rate, cage subsidence rate, postoperative neck pain as evaluated by visual analogue scale (VAS) and upper adjacent level segmental movement were evaluated. The average following time was 14.6 months. The mean change in lordotic curve was −2.31 ± 9.53° for Group A, 5.60 ± 6.96° for Group B, and 3.23 ± 7.50° for Group C (p value = 0.03). The mean change in flexion angle was −5.46 ± 8.69° for Group A, −10.2 ± 7.38° for Group B, and −13.86 ± 10.33° for Group C (p value = 0.039). The mean change in total cervical ROM was −3.85 ± 18.74° for Group A, −12.73 ± 10.31° for Group B, and −16.95 ± 10.57° for Group C (p value = 0.02). Follow-up cervical MRI for patients with persistent neck pain showed no evidence of adjacent level degeneration. There were no significant differences between the three groups with respect to postoperative change in cervical extension angle, upper adjacent level segmental movement, neck pain VAS, fusion rate or cage subsidence rate. The further decrease in total cervical ROM and flexion movement after multi-level ACDF was observed. However, a more long-term follow-up was needed to assess the actual aetiologies of upper adjacent level degeneration.

Posterior condylar offset and flexion in posterior cruciate-retaining and posterior stabilized TKA

BackgroundAnterior tibial translation associated with posterior impingement has been reported to be one of the factors limiting flexion after posterior cruciate-retaining (CR) total knee arthroplasty (TKA), especially when posterior condylar offset is decreased postoperatively. On the other hand, its effect on postoperative motion in posterior-stabilized (PS) TKA remains unknown. It has been demonstrated that PS TKA exhibits a consistent posterior femoral rollback during flexion. Thus, we hypothesized that the problem of posterior impingement can be avoided by use of PS TKA. In this study, we examined the relationship between postoperative posterior condylar offset and knee flexion in CR and PS TKAs. MethodsIn this study, analysis was performed for 20 subjects who underwent bilateral TKAs (one CR and one PS TKA) as well as another group of 50 PS TKAs. All patients could be tracked for a minimum of 2 years. The range of flexion was measured before operation and at follow-up. Preoperative and postoperative posterior condylar offset was evaluated on true lateral radiographs. ResultsAt the follow-up examination, the mean flexion angle was 123° in the CR knees and 131° in the PS knees with a significantly greater improvement observed for the latter group. In the roentgenographic measurement of the posterior condylar offset, no significant difference was observed between the preoperative and postoperative values both in the CR and PS knees. We divided the patients into two groups according to the change of posterior condylar offset. The first group (Group I) showed a decrease in the posterior condylar offset after surgery and the second group (Group II) showed no change or an increase. Subsequently, postoperative change in flexion was compared between Groups I and II for the CR and PS knees. A significant difference between Groups I and II was observed in the CR knees, while no difference was observed in the PS knees. The magnitude of postoperative posterior condylar offset did not correlate with an improvement in maximum flexion angle in the 50 PS knees. ConclusionsIt was shown that the magnitude of posterior condylar offset correlated with a postoperative change in flexion angle in CR knees, while no such correlation was observed in PS knees.

Strain in the human medial collateral ligament during valgus loading of the knee.

The medial collateral ligament is one of the most frequently injured ligaments in the knee. Although the medial collateral ligament is known to provide a primary restraint to valgus and external rotations, details regarding its precise mechanical function are unknown. In this study, strain in the medial collateral ligament of eight knees from male cadavers was measured during valgus loading. A material testing machine was used to apply 10 cycles of varus and valgus rotation to limits of +/- 10.0 N-m at flexion angles of 0 degrees, 30 degrees, 60 degrees, and 90 degrees. A three-dimensional motion analysis system measured local tissue strain on the medial collateral ligament surface within 12 regions encompassing nearly the entire medial collateral ligament surface. Results indicated that strain is significantly different in different regions over the surface of the medial collateral ligament and that this distribution of strain changes with flexion angle and with the application of a valgus torque. Strain in the posterior and central portions of the medial collateral ligament generally decreased with increasing flexion angle, whereas strain in the anterior fibers remained relatively constant with changes in flexion angle. The highest strains in the medial collateral ligament were found at full extension on the posterior side of the medial collateral ligament near the femoral insertion. These data support clinical findings that suggest the femoral insertion is the most common location for medial collateral ligament injuries.