Chain Degree Of Polymerization Research Articles

Morphologies of Planar Polyelectrolyte Brushes in a Poor Solvent: Molecular Dynamics Simulations and Scaling Analysis

Using molecular dynamics simulations and scaling analysis, we study the effect of the solvent quality for the polymer backbone, the strength of the electrostatic interactions, the chain degree of polymerization, and the brush grafting density on conformations of the planar polyelectrolyte brushes in salt-free solutions. Polyelectrolyte brush forms: (1) vertically oriented cylindrical aggregates (bundles of chains), (2) maze-like aggregate structures, or (3) thin polymeric layer covering a substrate. These different brush morphologies appear as a result of the fine interplay between electrostatic and short-range monomer-monomer interactions. The brush thickness shows nonmonotonic dependence on the value of the Bjerrum length. It first increases with the increasing value of the Bjerrum length, and then it begins to decrease. This behavior is a result of counterion condensation within a brush volume.

Optimization of functionalized polymer layers for specific targeting of mobile receptors on cell surfaces.

The reversible binding between a planar polymer layer functionalized by ligands and a planar cell surface containing different densities of mobile receptors has been studied by Monte Carlo simulations. Using the acceptance-ratio method, the distance-dependent profiles for the average number of ligands bound to receptors, the total free energy for the polymer layer-cell surface interaction and the interaction force were obtained. Four main design parameters for the polymer layer were considered: the degree of functionalization, chain degree of polymerization, polymer grafting density and the binding energy for the ligand-receptor interaction. We found that an increase in the degree of functionalization or in the absolute energy of ligand-receptor binding results in a larger number of ligands bound to the receptors, lower free energy, and stronger attractive force. Polymer layers composed of shorter chains were found to exhibit a deeper and narrower free energy profile and a larger attractive force, while longer tethers can interact with the cell surface at a larger and broader range of separation distances, in agreement with experimental observations. Our simulation results show that the increase in polymer grafting density from the mushroom to brush regime enhances the ligand availability and results in a stronger attractive force, increases the maximum binding distance, but exhibits a shallower free energy minimum due to the smaller tolerance to compression for polymer layers with high grafting density. We used two measures of the polymer layer binding affinity to the cell surface: the free energy minimum, related to the equilibrium binding constant and the fraction of bound ligands. We found that the polymer layers with a smaller chain length and grafting density, larger degree of functionalization, and larger absolute binding energy exhibit both a larger equilibrium binding constant to the cell surface and a larger average number of bound ligands, except for high binding energies when the maximum level of binding is reached independently of polymer length and grafting density. We showed that high binding specificity can be achieved by the polymer layers with intermediate ligand-receptor binding energies or an intermediate number of ligands, as a larger binding energy or number of ligands ensures a high binding affinity but lacks specificity while a smaller binding energy or number of ligands provides inadequate affinity. We found that the results for polymer layers with different properties follow a similar pattern when both high binding affinity to cells with high receptor density and high binding specificity are considered. As a result, the optimal design of the polymer layers can be achieved by using several different strategies, which are discussed.

Polymer chain dynamics at interfaces: Role of boundary conditions at solid interface

Using classical molecular dynamics simulations, we study the dynamical properties of a single polymer chain dissolved in an explicit solvent and strongly adsorbed at solid-liquid interface. To circumvent a serious challenge posed by finite size effects due to long-range hydrodynamic effects, we developed a correction procedure that substantially limits the finite size effects. Concurrently, we provide an analysis of distinctly different size effects in the directions transverse and normal to the interface. We find that on analytically smooth interfaces, corresponding to the slip boundary condition, the motions of the polymer chain and the surrounding solvent are hydrodynamically coupled. This leads to the chain diffusion coefficient D scaling with the chain degree of polymerization N as D approximately N(-3/4), consistent with the Zimm dynamics for strongly adsorbed chains. Introduction of transverse forces at the interface results in loss of correlation between the motion of the polymer chain and the solvent. Consequently, D approximately N(-1), which is a characteristic of the Rouse dynamics.

Rouse Dynamics of Polyelectrolyte Solutions: Molecular Dynamics Study

We performed molecular dynamics simulations of dilute and semidilute polyelectrolyte solutions without hydrodynamic interactions to study Rouse dynamics of polyelectrolytes. Polyelectrolyte solutions are modeled by an ensemble of bead−spring chains of charged Lennard-Jones particles with explicit counterions. The simulations were performed for partially and fully charged polymers with the number of monomers N = 25−373. We show that the simulations of the Rouse dynamics give qualitatively similar results to the experimentally observed dynamics of polyelectrolyte solutions. Our simulations showed that the chain relaxation time depends nonmonotonically on polymer concentration. In dilute solutions, this relaxation time exhibits very strong dependence on the chain degree of polymerization, τ ∼ N3. The chain relaxation time decreases with increasing polymer concentration of dilute solutions. This decrease in the chain relaxation time is due to chain contraction induced by counterion condensation. In the semidi...

Thermodynamics, Orientational Order and Elasticity of Strained Liquid Crystalline Melts and Elastomers

A microscopic polymer liquid-state theory has been developed for the structure, thermodynamics and mechanical properties of strained liquid crystalline elastomers. The theory captures the experimentally observed phenomenon of spontaneous distortion and establishes a direct correlation between it and the nematic order parameter. Strain induced softening of the elastic modulus is predicted to emerge due to coupling of the induced orientational order and anisotropic interchain excluded volume interactions. Comparison of our results with limited experiments shows good qualitative and sometimes quantitative agreement. The theory predicts that deformation in the liquid crystalline state results in an increase of the amplitude of density fluctuations (compressibility) which becomes more pronounced as chain degree of polymerization and/or segmental density are decreased.

Microscopic theory of orientational order, structure and thermodynamics in strained polymer liquids and networks.

A microscopic integral equation theory of the segmental orientational order parameter, structural correlations and thermodynamics of strained polymer solutions, melts and networks has been developed. The nonclassical problem of the consequences of intermolecular excluded volume repulsions and chain connectivity is addressed. The theory makes several novel predictions, including effective power law dependences of the orientational order parameter on monomer concentration and chain degree of polymerization, and strain hardening of the bulk modulus. The predictions of a nearly classical strain dependence, and supralinear scaling with segment concentration, of the strain-induced nematic order parameter is in agreement with nuclear magnetic resonance experiments. The absolute magnitudes of the a priori calculated orientational order parameter agree with simulations and experiments to within a factor of 2. The possible complicating influence of "trapped entanglements" in crosslinked networks is discussed. Extensions of the theory are possible to treat the mechanical response of flexible polymer liquids and rubbers, and the structure, thermodynamics, and mechanical properties of strained liquid crystal forming polymers.

Mode-coupling theory of self-diffusion in diblock copolymers I. General derivation and qualitative predictions

A microscopic theory of self-diffusion in diblock copolymer melts and solutions has been developed based on polymeric mode-coupling methods formulated at the level of the time and space correlated interchain excluded volume and chi-parameter forces. Equilibrium structural correlations are determined via microscopic liquid state integral equation or coarse-grained field theoretic methods. The specific dynamical consequences of self-assembly are predicted to depend rather sensitively on temperature, degree of polymerization, copolymer composition and concentration, and local block friction coefficients. The dominant physical effect for entangled diblocks is the retardation of the relaxation time of the interchain excluded volume forces due to the thermodynamically-driven segregation of blocks into microdomains, resulting in suppression of translational motion. Analytic analysis in the long chain limit allows the derivation of new scaling laws relating the self-diffusion constant and chain degree of polymerization and solution concentration. Potential limitations for real copolymer materials associated with the structurally and dynamically isotropic description adopted by the theory are discussed.