Bridgeless Single-ended Primary Inductance Converter Research Articles

Bridgeless SEPIC PFC Rectifier With Reduced Components and Conduction Losses

In this paper, a new bridgeless single-ended primary inductance converter power-factor-correction rectifier is introduced. The proposed circuit provides lower conduction losses with reduced components simultaneously. In conventional PFC converters (continuous-conduction-mode boost converter), a voltage loop and a current loop are required for PFC. In the proposed converter, the control circuit is simplified, and no current loop is required while the converter operates in discontinuous conduction mode. Theoretical analysis and simulation results are provided to explain circuit operation. A prototype of the proposed converter is realized, and the results are presented. The measured efficiency shows 1% improvement in comparison to conventional SEPIC rectifier.

Modeling and simulation of a new Bridgeless SEPIC power factor correction circuit

A new Bridgeless PFC circuit based on Single-Ended Primary Inductance Converter (SEPIC) is proposed in this paper. The new topology has less component count and less conducted component during each mode of operation within one switching period. The small-signal and steady-state model of the circuit operated in Discontinuous Conduction Mode (DCM) is derived using the Current Injected Equivalent Circuit Approach (CIECA). The large-signal model based on state-space and switch model are also developed to verify the large-signal behavior. The simulation results of the proposed converter show that the output voltage of the proposed converter is successfully regulated to its desired value while the input current regulation is inherent.

Bridgeless SEPIC Rectifier With Unity Power Factor and Reduced Conduction Losses

In this paper, a new bridgeless single-phase AC-DC converter with an automatic power factor correction (PFC) is proposed. The proposed rectifier is based on the single-ended primary inductance converter (SEPIC) topology and it utilizes a bidirectional switch and two fast diodes. The absence of an input diode bridge and the presence of only one diode in the flowing-current path during each switching cycle result in less conduction loss and improved thermal management compared to existing PFC rectifiers. Other advantages include simple control circuitry, reduced switch voltage stress, and low electromagnetic-interference noise. Performance comparison between the proposed and the conventional SEPIC PFC rectifier is performed. Simulation and experimental results are presented to demonstrate the feasibility of the proposed technique.