Bridgeless Power Factor Correction Circuit Research Articles

Performance investigation of bridge-less power factor correction circuit with MOSFET

The aim of this paper is to study and investigate the performance of power factor correction (PFC) circuit implemented with the semi bridge-less configuration. The transistor-diode module APT50N60JCCU2 has been used in the proposed circuit and the UCC28070 controller has been used as a controlling device for the power factor correction (PFC) circuit. Testing has been performed in two steps. In the first step, the test was conducted<br /> on (230 Vac), while in the second step, the test was conducted on (115 Vac) as alternating input voltages. The testing results of both voltages were compared and analyzed in terms of efficiency, power factor, total harmonic distortion (THD) in order to determine the efficiency of the power factor correction circuit. The results obtained indicate that this circuit has efficiency up to 97% and a power factor close to 0.91 with the input voltage of 230 V.

Improved Bridgeless Interleaved Boost PFC Rectifier with Optimized Magnetic Utilization and Reduced Sensing Noise

An improved bridgeless interleaved boost power factor correction (PFC) rectifier to improve power efficiency and component utilization is proposed in this study. With combined conventional bridgeless PFC circuit and interleaved technology, the proposed rectifier consists of two interleaved and magnetic inter-coupling boost bridgeless converter cells. Each cell operates alternatively in the critical conduction mode, which can achieve the soft-switching characteristics of the switches and increase power capacity. Auxiliary blocking diodes are employed to eliminate undesired circulating loops and reduce current-sensing noise, which are among the serious drawbacks of a dual-boost PFC rectifier. Magnetic component utilization is improved by symmetrically coupling two inductors on a unique core, which can achieve independence from each other based on the auxiliary diodes. Through the interleaved approach, each switch can operate in the whole line cycle. A simple control scheme is employed in the circuit by using a conventional interleaved controller. The operation principle and theoretical analysis of the converter are presented. A 600 W experimental prototype is built to verify the theoretical analysis and feasibility of the proposed rectifier. System efficiency reaches 97.3% with low total harmonic distortion at full load.

A Family of Zero-Voltage-Transition Bridgeless Power-Factor-Correction Circuits With a Zero-Current-Switching Auxiliary Switch

A novel zero-voltage-transition high-efficiency bridgeless power-factor-correction (PFC) circuit with a zero-current-switching auxiliary switch was proposed, analyzed, and experimentally verified. An assist circuit, consisting of a resonant inductor, two blocking diodes, a clamping circuit, an autotransformer, and an auxiliary MOSFET switch, was used to reduce the turn-on switching loss of the two main switches of the bridgeless PFC circuit and the turn-off switching loss of the auxiliary switch. The soft commutation of the main switches is achieved without imposing an additional voltage stress on the main switches. Feedback gate-drive signals can be obtained by using an existing converter IC controller modified to fit the purpose. In this paper, a detailed description of the circuit operation will be given. Based on the analysis, the guidelines for the component selection are presented. A prototype of 100-kHz 600-W universal-line PFC bridgeless circuit was built to verify the proposed scheme. In addition, based on the same concept, a family of bridgeless PFC configuration was proposed.