Bipolar DC Distribution System Research Articles

A Half-Bridge Voltage Balancer with New Controller for Bipolar DC Distribution Systems

This paper proposes a half-bridge voltage balancer with a new controller for bipolar DC distribution systems. The proposed control scheme consists of two cascaded Proportional Integral (PI) controls rather than one PI control for balancing the pole voltage. In order to confirm the excellence of voltage balancing performance, a typical bipolar DC distribution system including a half-bridge voltage balancer with proposed controller was analyzed by computer simulations. Experiments with a scaled prototype were also carried out to confirm the simulation results. The half-bridge voltage balancer with proposed controller shows better performance than the half-bridge voltage balancer with one PI control for balancing the pole voltage.

Analysis and Control of Bipolar LVDC Grid With DC Symmetrical Component Method

The dc symmetrical component method is introduced for the analysis and control of bipolar dc distribution systems under asymmetrical operation. This method is an extension of the classical symmetrical component theory in three-phase ac power systems. The asymmetrical voltage and current in the positive and negative poles are decomposed into symmetrical components in common and differential modes. The equivalent circuit for each mode is derived, which forms decoupled mode networks. Consequently, it allows for independent investigation of each mode, and provides an insightful view of the static and dynamic behavior of a bipolar dc power system. The dc symmetrical component method is a general approach which is applicable to different aspects of system design. As an example, an enhanced common-mode voltage regulation scheme is described. It suppresses common-mode LC resonance by adding active damping control, and reduces common-mode impedance to improve power quality and voltage stability. The major theoretical conclusions are verified by experimental results.

하드웨어 시뮬레이터에 의한 양극형 직류배전시스템의 동작특성 분석

This paper describes the operational analysis results of the bipolar DC distribution system coupled with the distributed generators. The energy management for AC/DC power trade and the operational principle of distributed generators and energy storages were first analyzed by computer simulation with PSCAD/EMTDC software. After then a hardware simulator for the bipolar DC distribution system was built, which is composed of the grid-tied three-level inverter, battery storage, super-capacitor storage, and the voltage balancer. Various experiments with the hardware simulator were carried out to verify the operation of bipolar DC distribution system. The developed simulator has an upper-level controller which operates in connection with the controllers for each distributed generator and the battery energy storage based on CAN communication. The developed hardware simulator are possible to use in designing the bipolar DC distribution system and analyzing its performance experimentally.