Biorelevant Dissolution Media Research Articles

In vivo in vitro correlations for a poorly soluble drug, danazol, using the flow-through dissolution method with biorelevant dissolution media

The purpose of the study was to design dissolution tests that were able to distinguish between the behaviour of danazol under fasted and fed conditions, by using biorelevant media. In vitro dissolution of 100 mg danazol capsules was performed using the flow-through dissolution method. Flow rates were 8, 16 or 32 ml/min, corresponding to total volumes dissolution medium of 960, 1920 and 3840 ml, respectively. The media used contained bile salt and phospholipid levels relevant for either fasted or fed conditions in vivo. Crude and inexpensive bile components, Porcine Bile Extract and soybean phospholipids, were used as the bile source. The effect of adding different concentrations and molar ratios of monoglycerides and fatty acids to the fed state media was investigated. In vivo release profiles under fasted and fed conditions were obtained from a previous study by deconvolution [Sunesen, V.H., Vedelsdal, R., Kristensen, H.G., Christrup, L., Müllertz, A. 2005. Effect of liquid volume and food intake on the absolute bioavailability of danazol, a poorly soluble drug, Eur. J. Pharm. Sci. 24, 297–303]. In the fasted state, the physiologically most relevant correlation with in vivo results was achieved with a medium containing 6.3 mM bile salts and 1.25 mM phospholipids (8 ml/min). A medium containing 18.8 mM bile salts, 3.75 mM phospholipids, 4.0 mM monoglycerides and 30 mM fatty acids (8 ml/min) gave the closest correlation with fed state in vivo results. By using the flow-through dissolution method it was possible to obtain correlations with in vivo release of danazol under fasted and fed conditions. Both hydrodynamics and medium composition were important for the dissolution of danazol. In the fed state an IVIVC could only be obtained by including monoglycerides and fatty acids in the medium.

Evaluation and Selection of Bio-relevant Dissolution Media for a Poorly Water-Soluble New Chemical Entity

The purpose of this work is to develop a bio-relevant dissolution method for formulation screening in order to select an enhanced bioavailable formulation for a poorly water-soluble drug. The methods used included a modified rotating disk apparatus for measuring intrinsic dissolution rate of the new chemical entity (NCE) and the USP dissolution method II for evaluating dissolution profiles of the drug in three different dosage forms. The in vitro dissolution results were compared with the in vivo bioavailability for selecting a bio-relevant medium. The results showed that the solubility of the NCE was proportional to the concentration of sodium lauryl sulfate (SLS) in the media. The apparent intrinsic dissolution rate of the NCE was linear to the rotational speed of the disk, which indicated that the dissolution of the drug is a diffusion-controlled mechanism. The apparent intrinsic dissolution rate was also linear to the surfactant concentration in the media, which was interpreted using the Noyes and Whitney Empirical Theory. Three formulations were studied in three different SLS media using the bulk drug as a reference. The dissolution results were compared with the corresponding bioavailability results in dogs. In the 1% SLS—sink conditions—the drug release from all the formulations was complete and the dissolution results were discriminative for the difference in particle size of the drug in the formulations. However, the data showed poor IVIV correlation. In the 0.5% SLS medium—non-sink conditions—the dissolution results showed the same rank order among the tested formulations as the bioavailability. The best IVIV correlation was obtained from the dissolution in 0.25% SLS medium, an over-saturated condition. The conclusions are: a surfactant medium increases the apparent intrinsic dissolution rate of the NCE linearly due to an increase in solubility. A low concentration of surfactant in the medium (0.25%) is more bio-relevant than higher concentrations of surfactant in the media for the poorly water-soluble drug. Creating sink conditions (based on bulk drug solubilities) by using a high concentration of a surfactant in the dissolution medium may not be a proper approach in developing a bio-relevant dissolution method for a poorly water-soluble drug.

Dissolution testing as a prognostic tool for oral drug absorption: dissolution behavior of glibenclamide.

The dissolution behavior of two commercially available glibenclamide formulations was tested in various media. The aim of the study was to investigate whether the use of biorelevant dissolution media (BDM) would be advantageous over the use of standard media for predicting the in vivo performance of the two formulations. The dissolution tests were performed using USP 23 apparatus 2. Conventional buffers and USP media were compared with two BDM containing different amounts of lecithin and sodium taurocholate. The dissolution of two drug powders was highly dependent on wetting, particle size, pH, and the composition of the medium used. In addition, the dissolution behavior of the two glibenclamide formulations showed differences in all media tested. The dissolution results of the two formulations were compared with those from an in vivo bioequivalence study undertaken by the central quality control laboratory of the German pharmacists (ZL). The bioequivalence criterion set by the ZL requires more than 80% drug release within 10 minutes. Results in FaSSIF, one of the BDMs, met the ZL criterion and this medium was also able to discriminate between the two formulations. This was not the case for the other media tested. The study indicates that BDM are better able to discriminate between glibenclamide formulations than standard dissolution media.