Biorefinery Purposes Research Articles

Seasonal and spatial variation in biochemical composition of Saccharina latissima during a potential harvesting season for Western Sweden

Abstract This study monitored the biomass composition of Saccharina latissima during a potential harvesting season on the West coast of Sweden, in order to find suitable harvest times for biorefinery purposes. Specimens of S. latissima were sampled at three locations in June, August and October and the biomass was analysed for its macromolecular composition, as well as for the content of several specific compounds, e.g. sugars and fatty acids. PERMANOVA analyses showed that there was a significant difference in the biomass composition among time points. The total carbohydrate concentration was lowest in June and peaked at 360 mg g-1 dry weight in August, while the mannitol content was highest, 90 mg g-1, in June and decreased throughout the sampling period. Total protein and fatty acid concentrations were found to be approximately 80 and 3 mg g-1, respectively, with relatively little variation over time. Overall, there was little spatial variation in the macromolecular composition, although the concentration of some specific monosaccharides and fatty acids, as well as the total phenolic content, differed among localities. We discuss the implications of the observed variation in biomass composition of S. latissima for future biorefinery purposes.

Restoration of female fertility in Trichoderma reesei QM6a provides the basis for inbreeding in this industrial cellulase producing fungus.

BackgroundFilamentous fungi are frequently used as production platforms in industrial biotechnology. Most of the strains involved were known as reproducing exclusively asexually thereby preventing the application of conventional strain breeding techniques. In the last decade, evidence was obtained that a number of these imperfect fungi possess a sexual life cycle, too. Trichoderma reesei, an industrial producer of enzymes for food, feed and biorefinery purposes, is heterothallic and takes a special position among industrially utilized species as all industrial strains are derived from the single MAT1-2 isolate QM6a. Consequently, strain improvement by crossing is not feasible within this strain line as this necessitates a MAT1-1 mating partner. Simply switching the mating type in one of the mating partners to MAT1-1, however, is not sufficient to produce a genotype capable of sexual reproduction with QM6a MAT1-2.ResultsWe have used a systems biology approach to identify genes restoring sexual reproduction in the QM6a strain line. To this end, T. reesei QM6a was crossed with the MAT1-1 wild-type strain CBS999.97. The descendants were backcrossed 8-times in two lineages with QM6a to obtain mating competent MAT1-1 strains with a minimal set of CBS999.97 specific genes. Comparative genome analysis identified a total of 73 genes of which two—encoding an unknown C2H2/ankyrin protein and a homolog of the WD-protein HAM5—were identified to be essential for fruiting body formation. The introduction of a functional ham5 allele in a mating type switched T. reesei QM6a allowed sexual crossing with the parental strain QM6a.ConclusionThe finding that Trichoderma reesei is generally capable of undergoing sexual reproduction even under laboratory conditions raised hope for the applicability of classical breeding techniques with this fungus as known for plants and certain yeasts. The discovery that the wild-type isolate QM6a was female sterile, however, precluded any progress along that line. With the discovery of the genetic cause of female sterility and the creation of an engineered fertile strain we now provide the basis to establish sexual crossing in this fungus and herald a new era of strain improvement in T. reesei.Electronic supplementary materialThe online version of this article (doi:10.1186/s13068-015-0311-2) contains supplementary material, which is available to authorized users.

Comparative attributional life cycle assessment of annual and perennial lignocellulosic feedstocks production under Mediterranean climate for biorefinery framework.

Annual fiber sorghum (FS) and perennial giant reed (GR) cultivated in the Mediterranean area are interesting due to their high productivity under drought conditions and their potential use as lignocellulosic feedstock for biorefinery purposes. This study compares environmental constraints related to FS and GR produced on experimental farms (in the Campania region) using an attributional life cycle assessment (LCA) approach through appropriate modeling of the perennial cultivation. For both crops, primary data were available for agricultural management. Direct field emissions (DFEs) were computed, including the potential soil carbon storage (SCS). Giant reed showed the lowest burdens for all impact categories analyzed (most were in the range of 40%-80% of FS values). More apparent were the differences for climate change and freshwater eutrophication (respectively 80% and 81% lower for GR compared to FS). These results are due to the short-term SCS, experimentally detected in the perennial GR crop (about 0.25 ton C ha(-1) yr(-1), with a global warming offsetting potential of about 0.03 ton CO2/ton(GR dry biomass)). The results are also due to the annual application of triple superphosphate at the sowing fertilization phase for FS, which occurs differently than it does for GR. Phosphorous fertilization was performed only when crops were being established and therefore properly spread along the overall crop lifetime. For both crops, after normalization, terrestrial acidification and particulate matter formation were relevant impact categories, as a consequence of the NH3 DFE by volatilization after urea were spread superficially. Therefore, the results suggest higher environmental benefits of the perennial crop than the annual crop.

Environmental Biotechnology: Current Advances, New Knowledge Gaps, and Emerging Issues.

Environmental Biotechnology: Current Advances, New Knowledge Gaps, and Emerging Issues.

MYCELIAL GROWTH AND ENZYMATIC ACTIVITIES OF WHITE-ROT FUNGI ON ANAEROBIC DIGESTATES FROM INDUSTRIAL BIOGAS PLANTS

Solid digestate (SD) represents an environmental problem due to the continuous increase of biogas production. In the present study four white-rot fungal strains were screened for their ability to grow on two different SD samples, obtained from industrial biogas plants, using wheat straw (WS) as a control medium. Results show that i) the feedstock used in the biogas plant influences the time required for the colonization of the corresponding SD and ii) different fungal strains have different capabilities to colonize the same digestate. In particular, Pleurotus ostreatus SMR 684 reached the maximum proliferation on corn silage digestate (CSD) in the shortest time (12 days). Subsequently, P. ostreatus was grown on WS and CSD for 42 days with measurement of lignocellulolytic activities and lignocellulose components (lignin, cellulose and hemicellulose). Enzymatic activities reached a maximum around the 24th day of incubation. Ligninolytic activities showed similar trends on CSD and on WS, while some differences were observed in the levels of cellulolytic and hemicellulolytic activities. Lignin was reduced by 12% on CSD, this suggesting that the fungal treatment can increase polysaccharides accessibility in view of a further utilization of SD for biorefinery purposes.

Improved Sugar Production by Optimizing Planetary Mill Pretreatment and Enzyme Hydrolysis Process.

This paper describes an optimization of planetary mill pretreatment and saccharification processes for improving biosugar production. Pitch pine (Pinus rigida) wood sawdust waste was used as biomass feedstock and the process parameters optimized in this study were the buffering media, the milling time, the enzyme quantity, and the incubation time. Glucose yields were improved when acetate buffer was used rather than citrate buffer. Initially, with each process variable tests, the optimal values were 100 minutes of milling, an enzyme concentration of 16 FPU/g-biomass, and a 12-hour enzymatic hydrolysis. Typically, interactions between these experimental conditions and their effects on glucose production were next investigated using RSM. Glucose yields from the Pinus rigida waste exceeded 80% with several of the conditions tested, demonstrating that milling can be used to obtain high levels of glucose bioconversion from woody biomass for biorefinery purposes.