The article analyses the results of autodeformation registered during tempering of carburized steel. Test pieces for the tests were carburized till the different depth in order to examine influence of depth of carburization on the deformation of steel during heat treatment operation. Carburization was performed on the one surface of test pieces seeking to analyze extent of acted normal stresses to autodeformation of steel. Different bending loads were applied for analyzed steel from 5 MPa to 100 MPa. Deflection of test pieces was analyzed. The obtained results proved that size and direction of deflection were affected by depth of carburization. Particular results of stretched and compressed surface examination showed different behavior of test pieces during tempering process. Test pieces, which undergo deformation at the beginning of martensitic transformation, after unloading bend further. When tempered test pieces with assimetrically carburized layer bend during hardening, its direction and extent of autodeformation depend on depth of carburization and tempering temperature. Kinetics of autodeformation (during tempering) is affected by difference of volume changes in the carburized part and in the unaffected low carbon part of specimen, and similarly by decomposition of retained austenite in the carburized part.DOI: http://dx.doi.org/10.5755/j01.ms.19.1.3820