B1I Signals Research Articles

Asymmetric Dual-Band Tracking Technique for Optimal Joint Processing of BDS B1I and B1C Signals.

Along with the rapid development of the Global Navigation Satellite System (GNSS), satellite navigation signals have become more diversified, complex, and agile in adapting to increasing market demands. Various techniques have been developed for processing multiple navigation signals to achieve better performance in terms of accuracy, sensitivity, and robustness. This paper focuses on a technique for processing two signals with separate but adjacent center frequencies, such as B1I and B1C signals in the BeiDou global system. The two signals may differ in modulation scheme, power, and initial phase relation and can be processed independently by user receivers; however, the propagation delays of the two signals from a satellite are nearly identical as they are modulated on adjacent frequencies, share the same reference clock, and undergo nearly identical propagation paths to the receiver, resulting in strong coherence between the two signals. Joint processing of these signals can achieve optimal measurement performance due to the increased Gabor bandwidth and power. In this paper, we propose a universal scheme of asymmetric dual-band tracking (ASYM-DBT) to take advantage of the strong coherence, the increased Gabor bandwidth, and power of the two signals in achieving much-reduced thermal noise and more accurate ranging results when compared with the traditional single-band algorithm.

Initial assessment of the COMPASS/BeiDou-3: new-generation navigation signals

The successful launch of five new-generation experimental satellites of the China’s BeiDou Navigation Satellite System, namely BeiDou I1-S, I2-S, M1-S, M2-S, and M3-S, marks a significant step in expanding BeiDou into a navigation system with global coverage. In addition to B1I (1561.098 MHz) and B3I (1269.520 MHz) signals, the new-generation BeiDou-3 experimental satellites are also capable of transmitting several new navigation signals in space, namely B1C at 1575.42 MHz, B2a at 1176.45 MHz, and B2b at 1207.14 MHz. For the first time, we present an initial characterization and performance assessment for these new-generation BeiDou-3 satellites and their signals. The L1/L2/L5 signals from GPS Block IIF satellites, E1/E5a/E5b signals from Galileo satellites, and B1I/B2I/B3I signals from BeiDou-2 satellites are also evaluated for comparison. The characteristics of the B1C, B1I, B2a, B2b, and B3I signals are evaluated in terms of observed carrier-to-noise density ratio, pseudorange multipath and noise, triple-frequency carrier-phase ionosphere-free and geometry-free combination, and double-differenced carrier-phase and code residuals. The results demonstrate that the observational quality of the new-generation BeiDou-3 signals is comparable to that of GPS L1/L2/L5 and Galileo E1/E5a/E5b signals. However, the analysis of code multipath shows that the elevation-dependent code biases, which have been previously identified to exist in the code observations of the BeiDou-2 satellites, seem to be not obvious for all the available signals of the new-generation BeiDou-3 satellites. This will significantly benefit precise applications that resolve wide-lane ambiguity based on Hatch–Melbourne–Wubbena linear combinations and other applications such as single-frequency precise point positioning (PPP) based on the ionosphere-free code–carrier combinations. Furthermore, with regard to the triple-frequency carrier-phase ionosphere-free and geometry-free combination, it is found that different from the BeiDou-2 and GPS Block IIF satellites, no apparent bias variations could be observed in all the new-generation BeiDou-3 experimental satellites, which shows a good consistency of the new-generation BeiDou-3 signals. The absence of such triple-frequency biases simplifies the potential processing of multi-frequency PPP using observations from the new-generation BeiDou-3 satellites. Finally, the precise relative positioning results indicate that the additional observations from the new-generation BeiDou-3 satellites can improve ambiguity resolution performance with respect to BeiDou-2 only positioning, which indicates that observations from the new-generation BeiDou-3 satellites can contribute to precise relative positioning.

Improve the Security of GNSS Receivers Through Spoofing Mitigation

Spoofing attacks are one of the most dangerous threats for the application of the global navigation satellite system (GNSS), especially for autonomous driving and unmanned aerial vehicles. In this paper, we present a more robust spoofing mitigation algorithm based on subspace projection that is independent of the number of antennas and that can be utilized in single-antenna GNSS receivers. During a spoofing attack, authentic signals are contaminated by spoofing signals. We demonstrate that all spoofing signals can be eliminated by projecting the received signal onto the orthogonal null space of the spoofing signals. Moreover, two types of receiver structures are designed: a centralized structure that has the ability to suppress cross-correlation interference and a distributed structure with lower computational complexity and lower projection power losses. The proposed algorithm is verified by the Beidou B1I signals for improving the security of the receiver.