In this study, Al2O3–20TiO2 (AT) and Cr2O3–3TiO2–5SiO2 (CT) coatings were prepared by atmospheric plasma spraying (APS), The microstructure, phase compositions and corrosion behavior were studied comparatively. The results indicated that both coatings had layered structure, with an average surface roughness RA around 6 μm, an adhesive strength around 35 MPa, and a porosity around 4 %. The AT coating mainly composed of γ-Al2O3 and α-Al2O3, and the CT coating composed Cr2O3 respectively. Moreover, the AT coating exhibited better corrosion resistance than the CT coating. In artificial seawater, the corrosion process was strongly related to the porosity. The corrosion rate (based on the corrosion current density) of the two coatings showed a same trend which decreased first and then increased. It was thought that the blocking of early corrosion products in holes was helpful to delaying the progress of corrosion. In contrast, the later corrosion products would promote the formation and propagation of cracks, accelerating the corrosion. In the simulated environment with high pressure and hydrogen sulfide seawater, the corrosion process was strongly related to the porosity as well as the brittleness of the coatings. The corrosion rate (based on the weight loss) of the AT coatings still remained the same trend as it in the artificial seawater. However, the CT coating showed a continuously increasing corrosion rate, due to higher porosity and brittleness resulted in a large number of cracks under external stress, which offered corrosion channels.