Atmospheric Pressure Micro Research Articles

Imaging gas and plasma interactions in the surface-chemical modification of polymers using micro-plasma jets

This paper reports on the correlation between gas flow and plasma behaviour in the outflow of a micro-atmospheric pressure plasma jet operating in helium using both 2D optical imaging and Schlieren photography. Schlieren photography shows that the helium outflow changes from laminar to turbulent conditions after distances between 20 and 50 mm from the nozzle. Above a flow rate of 1.4 slm, the length of the laminar region decreases with increasing flow rate. However, by contrast the visible plasma plume increases in length with increasing flow rate until its extension just exceeds that of the laminar region. At this point, the plasma becomes turbulent and its length decreases. Exposing polystyrene (PS) samples to the plasma jet significantly alters the water contact angle in a defined area, with the hydrophobic PS surface becoming more hydrophilic. This modification occurs both with and without direct contact of the visible glow on the surface. The radius of the treated area is much larger than the width of the visible jet but much smaller than the area of the turbulence on the surface. The treated area reduces with increasing nozzle–substrate distance.

Atomic oxygen formation in a radio-frequency driven micro-atmospheric pressure plasma jet

Atomic oxygen formation in a radio-frequency driven micro-atmospheric pressure plasma jet is investigated using both advanced optical diagnostics and numerical simulations of the dynamic plasma chemistry. Laser spectroscopic measurements of absolute densities of ground state atomic oxygen reveal steep gradients at the interface between the plasma core and the effluent region. Spatial profiles resolving the interelectrode gap within the core plasma indicate that volume processes dominate over surface reactions. Details of the production and destruction processes are investigated in numerical simulations benchmarked by phase-resolved optical emission spectroscopy. The main production mechanisms are electron induced and hence most efficient in the vicinity of the plasma boundary sheath, where electrons are energized. The destruction is driven through chemical heavy particle reactions. The resulting spatial profile of atomic oxygen is relatively flat. The power dependence of the atomic oxygen density obtained by the numerical simulation is in very good agreement with the laser spectroscopic measurements.

Investigation of gas–liquid interface in atmospheric-pressure micro plasma with solution

An atmospheric-pressure glow-discharge micro plasma in contact with liquid paraffin is stably generated by using a capacitively coupled plasma method with a mesh electrode. When characteristics of the plasma are measured in the boundary between the micro plasma (gas-phase) and liquid paraffin (liquid-phase) using optical emission spectroscopy, spectrum peaks of the emission of CH and C 2 which dissociate from paraffin are observed. The result indicates that solution can feed particles to the plasma at gas–liquid interface and this plasma is accordingly expected to promote an attractive plasma process for creating materials consisting of elements in various solutions.