Abstract: This paper’s purpose is to investigate tensile strength of FDM-print ABS components. FDM has evolved beyond rapid prototyping to rapid manufacturing in recent years, allowing items manufactured using the FDM process to be used immediately. Poor and anisotropic mechanical qualities, on the other hand, had a substantial influence on the use of fused model manufactured components. By carefully selecting framework, the automated qualities often FDM components can be improved. There will be three parameters on which the research is going through, angle of raster, height of layer, and breadth of raster, were chosen in this work to investigate their impact in the tensile samples. The components are manufactured to the ASTM D638 Type 4 standard. The inflated tensile strength was found with a angle of raster of 0 degrees. Because of the larger bonding surface between the layers, a lower layer height is associated with better tensile strength. The strength of a tensile component improves up to a point when the raster width is increased, after which the existence of void diminishes and tells how strong a material is when it is stretched.