Arc-based Additive Manufacturing Research Articles

Development of the shell structure building simulator with two-dimensional bead model for wire and arc-based additive manufacturing

Development of the shell structure building simulator with two-dimensional bead model for wire and arc-based additive manufacturing

Minimization of Thermal Distortion of Wire and Arc-based Additive Manufacturing on the Shaft

Minimization of Thermal Distortion of Wire and Arc-based Additive Manufacturing on the Shaft

Improvement in Geometrical Accuracy and Mechanical Property for Arc-Based Additive Manufacturing Using Metamorphic Rolling Mechanism

Additive manufacturing (AM), or 3D printing, is drawing considerable contemporary interest due to its characteristics of high material utilization, great flexibility in product design, and inherent moldless process. Arc-based AM (AAM) is a promising AM method with high deposition rate and favorable buildup quality. Components made by AAM are fabricated through superimposed weld beads deposited from metal wire. Unlike laser-based additive manufacturing, AAM is more difficult to control. Because of the large energy input of the energy source and the liquidity of the melting metal material, bottleneck problems like shrinkage porosity, cracking, residual stresses, and deformation occur. Resultant poor geometrical accuracy and mechanical property keep AAM from industrial application. Especially in the aerospace industry, structural and mechanical property specifications are stringent and critical. This paper presents a novel hybrid manufacturing method by using hot-rolling process to assist the arc welding to solve the above problems. Initially, a miniature metamorphic rolling mechanism (MRM) was developed using metamorphic mechanism theory. Configuration and topology of the MRM can change according to the feature of the components to roll the top and lateral surfaces of the bead. Subsequently, three single-pass multilayer walls were built, respectively, for comparison. The rolled results show significant improvement in geometrical accuracy of the built features. Tensile test results demonstrate improvement in mechanical properties. The improved mechanical properties of rolled specimens are superior to wrought material in travel direction. Microstructure comparisons indicate columnar grains observed in vertical direction and fusion zones were suppressed. Eventually, fabrication of a large-scale aerospace component validates the feasibility of industry application for the hybrid manufacturing technology.

Dissimilar metal deposition with a stainless steel and nickel-based alloy using wire and arc-based additive manufacturing

The wire and arc-based additive manufacturing process applies arc welding technology; the wire material is melted by the arc discharge, and is then accumulated successively in this process. The wire and arc-based additive manufacturing process directly and locally adds material to the molten pool. By changing the material locally during the process, more than one kind of material can be used simultaneously in a single manufactured component. In this study, two kinds of dissimilar metal deposition were conducted. A combination used was a stainless steel and Ni-based alloy. Mechanical properties near the interface such as hardness and bond strength were investigated. As a result, it was found that the mechanical properties of the manufactured alloy were comparable to those of a bulk material. In addition, an additive manufacturing system and a torch path planning method for using more than two kinds of material were proposed. By using this method, highly functional shapes whose surfaces and inner structures are made of different material could be made.

ワイヤ＋アーク放電によるAMと切削加工との連携システムの開発

ワイヤ＋アーク放電によるAMと切削加工との連携システムの開発