Adipose Tissue-derived Microvascular Fragments Research Articles

Seeding density is a crucial determinant for the in vivo vascularisation capacity of adipose tissue-derived microvascular fragments.

Adipose tissue-derived microvascular fragments (ad-MVF) represent effective vascularisation units for the seeding of dermal substitutes. However, particularly in case of extensive skin defects, the required amounts of donor fat tissue for the harvesting of ad-MVF may not always be available. Therefore, we herein determined the lowest ad-MVF density needed to induce a sufficient vascularisation and incorporation of seeded implants. Collagen-glycosaminoglycan matrices (Integra®; diameter: 4 mm) were seeded with 15,000 (HD), 10,000 (MD) and 5,000 (LD) ad-MVF and implanted into full-thickness skin defects within mouse dorsal skinfold chambers, to analyse their in vivo vascularisation and incorporation. Intravital fluorescence microscopy showed a comparable vascularisation of HD and MD ad-MVF-seeded Integra®, which was significantly higher when compared to LD ad-MVF-seeded Integra®. As assessed by photoacoustic imaging, this was associated with an increased oxygenation of the implants. Additional histological and immunohistochemical analyses revealed an enhanced cellular infiltration, collagen content, microvessel density and epithelialisation of HD and MD ad-MVF-seeded Integra®, indicating a better incorporation compared to LD ad-MVF-seeded implants. These findings demonstrate that 80,000 ad-MVF/cm² is the least required density to guarantee an effective vascularisation of the dermal substitute.

Isolation of Murine Adipose Tissue-derived Microvascular Fragments as Vascularization Units for Tissue Engineering.

A functional microvascular network is of pivotal importance for the survival and integration of engineered tissue constructs. For this purpose, several angiogenic and prevascularization strategies have been established. However, most cell-based approaches include time-consuming in vitro steps for the formation of a microvascular network. Hence, they are not suitable for intraoperative one-step procedures. Adipose tissue-derived microvascular fragments (ad-MVF) represent promising vascularization units. They can be easily isolated from fat tissue and exhibit a functional microvessel morphology. Moreover, they rapidly reassemble into new microvascular networks after in vivo implantation. In addition, ad-MVF have been shown to induce lymphangiogenesis. Finally, they are a rich source of mesenchymal stem cells, which may further contribute to their high vascularization potential. In previous studies we have demonstrated the remarkable vascularization capacity of ad-MVF in engineered bone and skin substitutes. In the present study, we report on a standardized protocol for the enzymatic isolation of ad-MVF from murine fat tissue.

Isolation of Murine Adipose Tissue-derived Microvascular Fragments as Vascularization Units for Tissue Engineering

Isolation of Murine Adipose Tissue-derived Microvascular Fragments as Vascularization Units for Tissue Engineering

Potentials and limitations of Integra® flowable wound matrix seeded with adipose tissue-derived microvascular fragments.

Adipose tissue-derived microvascular fragments (ad-MVF) represent promising vascularisation units for bioengineered Integra® matrix wound dressing (MWD). However, due to the sheet-like structure with small pore sizes, the seeding of this matrix with ad-MVF is mainly limited to its surface. Integra® flowable wound matrix (FWM) may be suitable to achieve a more homogeneous distribution and, thus, improved vascularisation, because this gel-like matrix allows for the direct admixture of ad-MVF during sample preparation. To test this hypothesis, we seeded MWD and FWM with an identical number of ad-MVF and assessed their distribution and inter-fragment distance within both matrices. Moreover, ad-MVF-seeded MWD and FWM were implanted into full-thickness skin defects within mouse dorsal skinfold chambers to analyse their vascularisation, epithelialisation and tissue incorporation using intravital fluorescence microscopy, histology and immunohistochemistry. Seeded FWM exhibited a more homogeneous ad-MVF distribution, when compared to MWD. This resulted in a significantly increased inter-fragment distance, preventing the reassembly of ad-MVF into new microvascular networks. Accordingly, the vascularisation of FWM was diminished after implantation, as indicated by a reduced functional microvessel density and blood perfusion. This was associated with a decreased tissue incorporation and epithelialisation of the matrix, when compared to ad-MVF-seeded MWD. Hence, the use of FWM as a carrier system may require a tremendous amount of ad-MVF to shorten their inter-fragment distance and, thus, to maintain their vascularisation capacity for tissue engineering applications.

Adipose Tissue-Derived Microvascular Fragments Improve Vascularization, Lymphangiogenesis, and Integration of Dermal Skin Substitutes

Full-thickness skin defects can be covered with dermal skin substitutes in combination with split-thickness skin grafts. However, slow vascularization of the matrices bears the risk of wound infection and extends the length of hospitalization. To overcome these problems, we describe a promising vascularization strategy. Green fluorescent protein+ adipose tissue-derived microvascular fragments (ad-MVF) were isolated from epididymal fat pads of C57BL/6-Tg(CAG-EGFP)1Osb/J mice. ad-MVF were seeded on collagen-glycosaminoglycan matrices, which were implanted into full-thickness skin defects in the dorsal skinfold chamber of wild-type C57BL/6 mice. Nonseeded matrices served as controls. Vascularization, lymphangiogenesis, and integration of the implants were studied by using intravital fluorescence microscopy, histology, and immunohistochemistry over 14 days. ad-MVF rapidly reassembled into microvascular networks within the implants, which developed interconnections to the host microvasculature. Accordingly, vascularization of the implants was markedly accelerated, as indicated by a significantly higher microvessel density when compared with controls. Moreover, dense lymphatic networks originating from the green fluorescent protein+ ad-MVF developed within the implants. This was associated with an improved implant integration. Hence, seeding ad-MVF on collagen-glycosaminoglycan matrices represents a potential strategy to reduce morbidity and hospitalization of patients undergoing the treatment of full-thickness skin defects.

Effects of macrophage-activating lipopeptide-2 (MALP-2) on the vascularisation of implanted polyurethane scaffolds seeded with microvascular fragments.

The seeding of scaffolds with adipose tissue-derived microvascular fragments represents a promising strategy to establish a sufficient blood supply in tissue constructs. Herein, we analysed whether a single application of macrophage-activating lipopeptide-2 (MALP-2) at the implantation site further improves the early vascularisation of such microvessel-seeded constructs. Microvascular fragments were isolated from epididymal fat pads of C57BL/6 mice. The fragments were seeded on polyurethane scaffolds, which were implanted into mouse dorsal skinfold chambers exposed to MALP-2 or vehicle (control). The inflammatory host tissue response and the vascularisation of the scaffolds were analysed using intravital fluorescence microscopy, histology and immunohistochemistry. We found that the numbers of microvascular adherent leukocytes were significantly increased in MALP-2-treated chambers during the first 3 days after scaffold implantation when compared to controls. This temporary inflammation resulted in an improved vascularisation of the host tissue surrounding the implants, as indicated by a higher density of CD31-positive microvessels at day 14. However, the MALP-2-exposed scaffolds themselves presented with a lower functional microvessel density in their centre. In addition, in vitro analyses revealed that MALP-2 promotes apoptotic cell death of endothelial and perivascular cells in isolated microvascular fragments. Hence, despite the beneficial pro-angiogenic properties of MALP-2 at the implantation site, the herein evaluated approach may not be recommended to improve the vascularisation capacity of microvascular fragments in tissue engineering applications.

Pre-cultivation of adipose tissue-derived microvascular fragments in porous scaffolds does not improve their in vivo vascularisation potential.

Adipose tissue-derived microvascular fragments represent promising vascularisation units for implanted tissue constructs. However, their reassembly into functional microvascular networks takes several days, during which the cells inside the implants are exposed to hypoxia. In the present study, we analysed whether this critical phase may be overcome by pre-cultivation of fragment-seeded scaffolds prior to their implantation. Green fluorescent protein (GFP)-positive microvascular fragments were isolated from epididymal fat pads of male C57BL/6-TgN (ACTB-EGFP) 1Osb/J mice. Nano-size hydroxyapatite particles/poly (ester-urethane) scaffolds were seeded with these fragments and cultivated for 28 days. Subsequently, these scaffolds or control scaffolds, which were freshly seeded with GFP-positive microvascular fragments, were implanted into the dorsal skinfold chamber of C57BL/6 wild-type mice to study their vascularisation and incorporation by means of intravital fluorescence microscopy, histology and immunohistochemistry over 2 weeks. Pre-cultivation of microvascular fragments resulted in the loss of their native vessel morphology. Accordingly, pre-cultivated scaffolds contained a network of individual CD31/GFP-positive endothelial cells with filigrane cell protuberances. After implantation into the dorsal skinfold chamber, these scaffolds exhibited an impaired vascularisation, as indicated by a significantly reduced functional microvessel density and lower fraction of GFP-positive microvessels in their centre when compared to freshly seeded control implants. This was associated with a deteriorated incorporation into the surrounding host tissue. These findings indicate that freshly isolated, non-cultivated microvascular fragments should be preferred as vascularisation units. This would also facilitate their use in clinical practice during intra-operative one-step procedures.

Adipose tissue-derived microvascular fragments from aged donors exhibit an impaired vascularisation capacity.

Adipose tissue-derived microvascular fragments are promising vascularisation units for applications in the field of tissue engineering. Elderly patients are the major future target population of such applications due to an increasing human life expectancy. Therefore, we herein investigated the effect of aging on the fragments' vascularisation capacity. Microvascular fragments were isolated from epididymal fat pads of adult (8 months) and aged (16 months) C57BL/6 donor mice. These fragments were seeded onto porous polyurethane scaffolds, which were implanted into dorsal skinfold chambers to study their vascularisation using intravital fluorescence microscopy, histology and immunohistochemistry. Scaffolds seeded with fragments from aged donors exhibited a significantly lower functional microvessel density and intravascular blood flow velocity. This was associated with an impaired vessel maturation, as indicated by vessel wall irregularities, constantly elevated diameters and a lower fraction of CD31/α-smooth muscle actin double positive microvessels in the implants' border and centre zones. Additional in vitro analyses revealed that microvascular fragments from adult and aged donors do not differ in their stem cell content as well as in their release of angiogenic growth factors, survival and proliferative activity under hypoxic conditions. However, fragments from aged donors exhibit a significantly lower number of matrix metalloproteinase -9-positive perivascular cells. Taken together, these findings demonstrate that aging is a crucial determinant for the vascularisation capacity of isolated microvascular fragments.

Vascularisation of porous scaffolds is improved by incorporation of adipose tissue-derived microvascular fragments

In tissue engineering, the generation of tissue constructs comprising preformed microvessels is a promising strategy to guarantee their adequate vascularisation after implantation. Herein, we analysed whether this may be achieved by seeding porous scaffolds with adipose tissue-derived microvascular fragments. Green fluorescent protein (GFP)-positive microvascular fragments were isolated by enzymatic digestion from epididymal fat pads of male C57BL/6-TgN(ACTB-EGFP)1Osb/J mice. Nano-size hydroxyapatite particles/poly(ester-urethane) scaffolds were seeded with these fragments and implanted into the dorsal skinfold chamber of C57BL/6 wild-type mice to study inosculation and vascularisation of the implants by means of intravital fluorescence microscopy, histology and immunohistochemistry over 2 weeks. Empty scaffolds served as controls. Vital microvascular fragments could be isolated from adipose tissue and seeded onto the scaffolds under dynamic pressure conditions. In the dorsal skinfold chamber, the fragments survived and exhibited a high angiogenic activity, resulting in the formation of GFP-positive microvascular networks within the implants. These networks developed interconnections to the host microvasculature, resulting in a significantly increased functional microvessel density at day 10 and 14 after implantation when compared to controls. Immunohistochemical analyses of vessel-seeded scaffolds revealed that >90 % of the microvessels in the implants' centre and ~60 % of microvessels in the surrounding host tissue were GFP-positive. This indicates that the scaffolds primarily vascularised by external inosculation. These novel findings demonstrate that the vascularisation of implanted porous scaffolds can be improved by incorporation of microvascular fragments. Accordingly, this approach may markedly contribute to the success of future tissue engineering applications in clinical practice.